VDSL2 wireless router with 4x100M ethernet ports.
DSL will not work at all on devices with BCM63xx DSL chipset (due to unavailability of FLOSS driver for Broadcom chips). Consider this when chosing a device to buy, or when deciding to flash OpenWrt on your device because it is listed as supported.
See Broadcom DSL, Unsupported: DSL modem and Broadcom BCM63xx for details.
Brand | Model | Version | Current Release | OEM Info | Forum Topic | Technical Data |
---|---|---|---|---|---|---|
ZyXEL | P-870HW-51a | v2 | 18.06.5 | View/Edit data |
Model | Version | SoC | CPU MHz | Flash MB | RAM MB | WLAN Hardware | WLAN2.4 | WLAN5.0 | 100M ports | Gbit ports | Modem | USB |
---|---|---|---|---|---|---|---|---|---|---|---|---|
P-870HW-51a | v2 | Broadcom BCM6368 | 400 | 4 | 32 | Broadcom BCM4318 | b/g | - | 4 | - | xDSL | - |
Installation procedure to be added here.
Internals: http://zyxel.tradesp.eu/images/open_870.png Dead link — tmomas 2018/04/06 09:10
Architecture | MIPS |
---|---|
Vendor | Broadcom |
bootloader | CFE |
System-On-Chip | BCM6368 |
Board ID | 96368VVW |
CPU/Speed | BCM4350 V3.1 / 400MHz |
Flash size | 4 MiB |
Flash-Chip | cFeon EN29LV320BB-70 |
RAM | 32 MiB |
RAM-Chip | Winbond W9412G6IH-5? x2 |
Wireless | BCM4318 b/g (onboard) |
Ethernet | 4x 100M |
Internet | VDSL/VDSL2 |
USB | No |
Serial | Yes |
JTAG | Seems no |
→ port.serial general information about the serial port, serial port cable, etc.
How to connect to the Serial Port of this specific device:
Pin | Signal |
---|---|
1 | VCC ![]() |
2 | TxD |
3 | RxD |
4 | N/A |
5 | GND |
Configure terminal with: baud rate 115200 and 8N1 (8 bits, No parity bit, 1 stop bit)