Precidia POSlynxWRT

Supported with souce code hosted on Directlink: http://www.precidia.com/support-2/downloads-2/

SoC Ram Flash Network USB Serial JTag
NXP LPC32XX@266MHz 64MiB 128MiB 1 No Yes ?
Instruction set ARM
Vendor NXP Semiconductors
bootloader U-Boot
System-On-Chip LPC32XX
CPU @Frq ARM926EJ-S CPU @450 MHz
Flash size 64 MiB
Flash Chip Samsung_K9F1G08U0D
RAM size 128 MiB
RAM Chip MT47H128M8
switch ASIX Electronics AX88613
USB No
Serial Yes
JTAG Yes

port.serial general information about the serial port, serial port cable, etc.

How to connect to the Serial Port of this specific device:
Insert photo of PCB with markings for serial port

FIXME Replace EXAMPLE by real values.

Serial connection parameters
for Precidia POSlynxWRT
EXAMPLE 115200, 8N1

port.jtag general information about the JTAG port, JTAG cable, etc.

How to connect to the JTAG Port of this specific device:
Insert photo of PCB with markings for JTAG port

tarting the kickstart... Loading the u-boot... Starting the u-boot... U-Boot 2009.03 (Mar 13 2012 - 09:32:08) Board: iPocket+ RS232(PoslynxMini) DRAM: 64 MB NAND: 128 MiB In: serial Out: serial Err: serial Hit any key to stop autoboot: 0 Loading from NAND 128MiB 3,3V 8-bit, offset 0x200000 Image Name: POSLynxMINI OpenWrt Linux-2.6.34 Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 6073252 Bytes = 5.8 MB Load Address: 80008000 Entry Point: 80008000 ## Booting kernel from Legacy Image at 82000000 ... Image Name: POSLynxMINI OpenWrt Linux-2.6.34 Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 6073252 Bytes = 5.8 MB Load Address: 80008000 Entry Point: 80008000 Verifying Checksum ... OK Loading Kernel Image ... OK OK


Starting kernel ... Uncompressing Linux... done, booting the kernel. Š[ 0.000000] Linux version 2.6.34.7 (kmu@vanimo) (gcc version 4.8.0 (OpenWrt GCC 4.8.0 unknown) ) #8 PREEMPT Fri Mar 13 00:00:32 EDT 2015 [ 0.000000] CPU: ARM926EJ-S [41069264] revision 4 (ARMv5TEJ), cr=00053177 [ 0.000000] CPU: VIVT data cache, VIVT instruction cache [ 0.000000] Machine: Precidia POSLynx110 Board [ 0.000000] Memory policy: ECC disabled, Data cache writeback [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256 [ 0.000000] Kernel command line: console=ttyS0,115200n8 ethaddr=00:01:1E:0B:1F:95 bootloader=1.1 hardware=PoslynxMini [ 0.000000] PID hash table entries: 256 (order: -2, 1024 bytes) [ 0.000000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) [ 0.000000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) [ 0.000000] Memory: 64MB = 64MB total [ 0.000000] Memory: 57260k/57260k available, 8276k reserved, 0K highmem [ 0.000000] Virtual kernel memory layout: [ 0.000000] vector : 0xffff0000 - 0xffff1000 ( 4 kB) [ 0.000000] fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB) [ 0.000000] DMA : 0xffc00000 - 0xffe00000 ( 2 MB) [ 0.000000] vmalloc : 0xc4800000 - 0xf0000000 ( 696 MB) [ 0.000000] lowmem : 0xc0000000 - 0xc4000000 ( 64 MB) [ 0.000000] modules : 0xbf000000 - 0xc0000000 ( 16 MB) [ 0.000000] .init : 0xc0008000 - 0xc0470000 (4512 kB) [ 0.000000] .text : 0xc0470000 - 0xc0752000 (2952 kB) [ 0.000000] .data : 0xc0752000 - 0xc0770900 ( 123 kB) [ 0.000000] Hierarchical RCU implementation. [ 0.000000] NR_IRQS:96 [ 0.000000] Calibrating delay loop... 103.83 BogoMIPS (lpj=519168) [ 0.180000] Mount-cache hash table entries: 512 [ 0.180000] CPU: Testing write buffer coherency: ok [ 0.180000] NET: Registered protocol family 16 [ 3.200000] LPC32XX unique ID: 000647217570216e571c91c850b13080 [ 3.230000] bio: create slab <bio-0> at 0 [ 3.230000] SCSI subsystem initialized [ 3.240000] usbcore: registered new interface driver usbfs [ 3.240000] usbcore: registered new interface driver hub [ 3.240000] usbcore: registered new device driver usb [ 3.240000] Switching to clocksource lpc32xx_clksrc [ 3.250000] NET: Registered protocol family 2 [ 3.250000] IP route cache hash table entries: 1024 (order: 0, 4096 bytes) [ 3.250000] TCP established hash table entries: 2048 (order: 2, 16384 bytes) [ 3.250000] TCP bind hash table entries: 2048 (order: 1, 8192 bytes) [ 3.250000] TCP: Hash tables configured (established 2048 bind 2048) [ 3.250000] TCP reno registered [ 3.250000] UDP hash table entries: 256 (order: 0, 4096 bytes) [ 3.250000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) [ 3.250000] NET: Registered protocol family 1 [ 3.250000] RPC: Registered udp transport module. [ 3.250000] RPC: Registered tcp transport module. [ 3.250000] RPC: Registered tcp NFSv4.1 backchannel transport module. [ 26.720000] NetWinder Floating Point Emulator V0.97 (double precision) [ 26.730000] JFFS2 version 2.2 (NAND) (ZLIB) (RTIME) (c) 2001-2006 Red Hat, Inc. [ 26.730000] msgmni has been set to 111 [ 26.760000] alg: No test for stdrng (krng) [ 26.760000] io scheduler noop registered [ 26.760000] io scheduler deadline registered [ 26.760000] io scheduler cfq registered (default) [ 26.760000] Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled [ 26.770000] serial8250.0: ttyS0 at MMIO 0x40090000 (irq = 9) is a 16550A [ 27.080000] console [ttyS0] enabled [ 27.080000] serial8250.0: ttyS1 at MMIO 0x40080000 (irq = 7) is a 16550A [ 27.100000] brd: module loaded [ 27.120000] loop: module loaded [ 27.130000] NAND device: Manufacturer ID: 0xec, Chip ID: 0xf1 (Samsung NAND 128MiB 3,3V 8-bit) [ 27.140000] Scanning device for bad blocks [ 27.180000] Bad eraseblock 577 at 0x000004820000 [ 27.220000] Creating 4 MTD partitions on "lpc32xx_nand": [ 27.220000] 0x000000000000-0x0000000a0000 : "Bootloader" [ 27.230000] 0x0000000a0000-0x000000200000 : "Bootenv" [ 27.240000] 0x000000200000-0x000001600000 : "Kernel" [ 27.250000] 0x000001600000-0x000008000000 : "Files" [ 27.270000] lpc_mii_bus: probed [ 27.270000] eth0: using MII interface [ 27.270000] eth0: LPC mac at 0x31060000 irq 29 [ 27.280000] eth0: attached PHY driver [Generic PHY] (mii_bus:phy_addr=0:01, irq=-1) [ 27.290000] ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver [ 29.290000] ohci_hcd: failed to connect I2C to ISP1301 USB Transceiver [ 29.290000] usbcore: registered new interface driver cdc_acm [ 29.300000] cdc_acm: v0.26:USB Abstract Control Model driver for USB modems and ISDN adapters [ 29.310000] PNX4008-WDT: PNX4008 Watchdog Timer: heartbeat 19 sec [ 29.320000] cpuidle: using governor ladder [ 29.320000] cpuidle: using governor menu [ 29.330000] usbcore: registered new interface driver hiddev [ 29.340000] usbcore: registered new interface driver usbhid [ 29.340000] usbhid: USB HID core driver [ 29.350000] TCP cubic registered [ 29.350000] NET: Registered protocol family 17 [ 29.360000] VFP support v0.3: implementor 41 architecture 1 part 10 variant 9 rev 1 [ 29.370000] Freeing init memory: 4512K - preinit - Press the [f] key and hit [enter] to enter failsafe mode - regular preinit - - init - Please press Enter to activate this console. [ 35.580000] ip_tables: (C) 2000-2006 Netfilter Core Team [ 36.190000] nf_conntrack version 0.5.0 (965 buckets, 3860 max) [ 36.190000] CONFIG_NF_CT_ACCT is deprecated and will be removed soon. Please use [ 36.200000] nf_conntrack.acct=1 kernel parameter, acct=1 nf_conntrack module option or [ 36.210000] sysctl net.netfilter.nf_conntrack_acct=1 to enable it. [ 37.450000] xt_time: kernel timezone is -0000 [ 58.420000] klips_info:ipsec_init: KLIPS startup, Openswan KLIPS IPsec stack version: 2.6.37-ge51f5001-dirty [ 58.440000] NET: Registered protocol family 15 [ 58.450000] registered KLIPS /proc/sys/net [ 58.480000] klips_info:ipsec_alg_init: KLIPS alg v=0.8.1-0 (EALG_MAX=255, AALG_MAX=251) [ 58.480000] klips_info:ipsec_alg_init: calling ipsec_alg_static_init() [ 58.510000] ipsec_aes_init(alg_type=15 alg_id=12 name=aes): ret=0 [ 58.510000] ipsec_aes_init(alg_type=14 alg_id=9 name=aes_mac): ret=0 [ 58.540000] ipsec_3des_init(alg_type=15 alg_id=3 name=3des): ret=0 [ 58.660000] KLIPS cryptoapi interface: alg_type=15 alg_id=12 name=cbc(aes) keyminbits=128 keymaxbits=256, found(0) [ 58.840000] KLIPS cryptoapi interface: alg_type=15 alg_id=253 name=cbc(twofish) keyminbits=128 keymaxbits=256, found(0) [ 58.960000] KLIPS cryptoapi interface: alg_type=15 alg_id=252 name=cbc(serpent) keyminbits=128 keymaxbits=256, found(0) [ 59.120000] KLIPS cryptoapi interface: alg_type=15 alg_id=6 name=cbc(cast5) keyminbits=128 keymaxbits=128, found(0) [ 59.230000] KLIPS cryptoapi interface: alg_type=15 alg_id=7 name=cbc(blowfish) keyminbits=96 keymaxbits=448, found(0) [ 59.330000] KLIPS cryptoapi interface: alg_type=15 alg_id=3 name=cbc(des3_ede) keyminbits=192 keymaxbits=192, found(0) [ 59.760000] BusyBox v1.19.4 (2015-03-12 21:52:14 EDT) built-in shell (ash) Enter 'help' for a list of built-in commands. _______ ________ __ | |.-----.-----.-----.| | | |.----.| |_ | - || _ | -__| || | | || _|| _| |_______|| __|_____|__|__||________||__| |____| |__| W I R E L E S S F R E E D O M ----------------------------------------------------- ATTITUDE ADJUSTMENT (Attitude Adjustment, unknown) ----------------------------------------------------- * 1/4 oz Vodka Pour all ingredients into mixing * 1/4 oz Gin tin with ice, strain into glass. * 1/4 oz Amaretto * 1/4 oz Triple sec * 1/4 oz Peach schnapps * 1/4 oz Sour mix * 1 splash Cranberry juice ----------------------------------------------------- root@OpenWrt:/#


This website uses cookies. By using the website, you agree with storing cookies on your computer. Also you acknowledge that you have read and understand our Privacy Policy. If you do not agree leave the website.More information about cookies
  • Last modified: 2018/06/02 19:54
  • by tmomas