NETGEAR VVG2000-1
This is an ADSL voice gateway offered by Netgear through service providers (i.e. not retail) (in Europe only?). It is currently unsupported on OpenWRT and is unlikely that it will be in the reasonable future (SoC, ADSL, and Voice DSP not currently supported in OpenWRT).
Not supported
Hardware Highlights
| CPU | Ram | Flash | Network | USB | Serial | JTag | Voice |
|---|---|---|---|---|---|---|---|
| Broadcom 96368 | 32 MiB | 8 MiB | ADSL, 4x 100M | 1x 2.0 | Yes | ? | 2 x FXS |
Hardware
Info
| Architecture: MIPS32 (big endian) |
| Vendor: Broadcom |
| Bootloader: CFE |
| System-On-Chip: BCM6368 |
| CPU Speed: 400 Mhz |
| Flash-Chip: 290LV640DBTC-90G |
| Flash size: 8 MiB |
| RAM: 32 MiB / Nanya 2 NT5SDS8M16FS-5T |
| Wireless: Broadcom BCM4322LKBFG (802.11 b/g/n) |
| ADSL: SoC |
| Ethernet: 4-port 100BaseT Switch / ? |
| USB: 1 x USB 2.0 ports |
| Voice: Microsemi Le88221DLC (VE880 VoicePort Series) |
| Serial: Yes |
| JTAG: ? |
Photos
ToDo --- CShore 2010-10-07
Opening the case
The case is held in place by six Torx T8 screws. Two are visible and the other four are underneath the rubber feet at each corner of the device. Once you've removed the screws simply lift off the cover.
Serial
A 1×6 pin header (J6) is located behind the LEDs on the left-middle of the board
[GD] [RX] [TX] [ ] [ ] [ ] |
Serial port settings are 115200@8n1.
Source Code
The GPL source code for firmware is supplied by Netgear here: http://kb.netgear.com/app/answers/detail/a_id/2649