TP-Link TL-7DR3630 1.0
Write a short, relevant description of the device. Include a technical overview, but avoid marketing buzzwords/useless stuff. Two to four sentences is about right. A picture is good, too. Edit the page to see how to add pictures.
OpenWrt support
Not supported.
Hardware highlights
| CPU | Ram | Flash | Network | WLAN | USB | Serial | JTag |
|---|---|---|---|---|---|---|---|
| EXAMPLE RT3052 @ 384 MHz | 64 MiB | 8 MiB | 4x 10/100 | bgn | 1x 2.0 | Yes | ? |
Hardware
Info
| Architecture | EXAMPLE MIPS |
|---|---|
| Vendor | EXAMPLE Ralink |
| Bootloader | EXAMPLE U-Boot |
| System-On-Chip | EXAMPLE Ralink RT3052 - MIPS 24K V4.12 |
| CPU/Speed | EXAMPLE 451 MHz |
| Flash-Chip | EXAMPLE unkown |
| Flash size | EXAMPLE 8 MiB |
| RAM | EXAMPLE 64 MiB |
| Wireless | EXAMPLE RT2860v2 2.4GHz 802.11bgn |
| Ethernet | EXAMPLE 10/100 Mbit/s w/ vlan support |
| Switch | EXAMPLE Qualcomm Atheros QCA8337 |
| USB | EXAMPLE 1x 2.0 |
| Serial | EXAMPLE Yes |
| JTAG | EXAMPLE Not populated |
Photos
Insert photo of front of the casing
Insert photo of back of the casing
Insert photo of backside label
Insert photo of PCB
Opening the case
Describe what needs to be done to open the device, e.g. remove rubber feet, adhesive labels, screws, ...
Serial
→ port.serial general information about the serial port, serial port cable, etc.
How to connect to the Serial Port of this specific device:
Insert photo of PCB with markings for serial port
Replace EXAMPLE by real values.
| Serial connection parameters for TP-Link TL-7DR3630 1.0 | EXAMPLE 115200, 8N1, 3.3V |
|---|
JTAG
→ port.jtag general information about the JTAG port, JTAG cable, etc.
How to connect to the JTAG Port of this specific device:
Insert photo of PCB with markings for JTAG port
Bootlogs
OEM bootlog
COPY HERE THE BOOTLOG WITH THE ORIGINAL FIRMWARE
OpenWrt bootlog
COPY HERE THE BOOTLOG ONCE OPENWRT IS INSTALLED AND RUNNING