MikroTik RBGrooveGA-52HPacn
The Groove 52ac is a compact outdoor wireless access point with a single gigabit ethernet port and 802.11ac wireless.
OpenWrt support
Not supported.
Hardware highlights
| CPU | Ram | Flash | Network | WLAN | USB | Serial | JTag |
|---|---|---|---|---|---|---|---|
| QCA9550L @ 720 MHz | 512 MiB | 128 MiB | 1x 10/100/1000 | b/g/n/a/ac | 0 | Yes | Yes |
Hardware
Info
| Architecture | MIPSBE |
|---|---|
| Vendor | MikroTik |
| Bootloader | RouterBoot |
| System-On-Chip | QCA9550L |
| CPU/Speed | 720 MHz |
| Flash-Chip | W25Q128FVFG - NOR |
| Flash size | 16 MiB |
| RAM | 64 MiB |
| Wireless | QCA9889 5 GHz 802.11ac and 2.4GHz 802.11bgn |
| Ethernet | AR8033 10/100/1000 Mbit/s w/ vlan support |
| Switch | None |
| USB | None |
| Serial | Not populated |
| JTAG | Not populated |
Photos
Insert photo of front of the casing
Insert photo of back of the casing
Insert photo of backside label
Insert photo of PCB
Opening the case
Describe what needs to be done to open the device, e.g. remove rubber feet, adhesive labels, screws, ...
Serial
→ port.serial general information about the serial port, serial port cable, etc.
How to connect to the Serial Port of this specific device:
Insert photo of PCB with markings for serial port
Replace EXAMPLE by real values.
| Serial connection parameters for MikroTik RBGrooveGA-52HPacn @@Version@@ | EXAMPLE 115200, 8N1, 3.3V |
|---|
JTAG
→ port.jtag general information about the JTAG port, JTAG cable, etc.
How to connect to the JTAG Port of this specific device:
Insert photo of PCB with markings for JTAG port
Bootlogs
OEM bootlog
COPY HERE THE BOOTLOG WITH THE ORIGINAL FIRMWARE
OpenWrt bootlog
COPY HERE THE BOOTLOG ONCE OPENWRT IS INSTALLED AND RUNNING