OpenWrt 24.10.0-rc6 - Sixth Release Candidate - 24. January 2025

  _______                     ________        __
 |       |.-----.-----.-----.|  |  |  |.----.|  |_
 |   -   ||  _  |  -__|     ||  |  |  ||   _||   _|
 |_______||   __|_____|__|__||________||__|  |____|
          |__| W I R E L E S S   F R E E D O M
 -----------------------------------------------------
 OpenWrt 24.10.0-rc6, r28388-58d0057481
 -----------------------------------------------------

The OpenWrt community is proud to announce the sixth release candidate of the upcoming OpenWrt 24.10 stable series.

This is just a release candidate and not the final release yet.

Download firmware images via the Firmware Selector or directly from our download servers:

• Download firmware image for your device (firmware selector)
• Download firmware images directly from OpenWrt download servers

An upgrade from OpenWrt 23.05 to OpenWrt 24.10 is supported in many cases with the help of the sysupgrade utility which will also attempt to preserve the configuration. A configuration backup is advised nonetheless when upgrading to OpenWrt 24.10. (see “Upgrading” below).

This is not the final version, this is a test version. Please report problems and bugs in our issue tracker. If there is already an existing ticket feel free to comment that the problem also occurs with OpenWrt 24.10.0-rc6.

The OpenWrt Project is a Linux operating system targeting embedded devices. It is a complete replacement for the vendor-supplied firmware of a wide range of wireless routers and non-network devices. See the Table of Hardware for supported devices. For more information about OpenWrt project organization, see the About OpenWrt pages.

Do you want to be informed about important changes such as new releases and security fixes?

We have a new mailing list for this, as well as RSS options: see Important changes and announcements.

Target changes:

• airoha: Multiple fixes
• apm821xx: WNDAP620 + WNDAP660: Fix sysupgrade failures
• armsr: change image names to 'combined-efi'
• ath79: AR9344: fixes spurious reset hangs
• ath79: meraki-mr18: fix initramfs build
• ath79: teltonika-rut230: fix failsafe boot without SIM tray
• ath79: zte-mf28x-common: fix initramfs execution
• d1: Use correct module for devices with wifi
• ipq4019: FritzBox 7530: Fix initialization of Lantiq DSL
• ipq40xx: Fix MAC address
• kernel: Realtek PHY improvements
• lantiq: AVM FritzBox 7430: Add fritz_cal_extract with reverse option
• lantiq: xrx200_legacy: disable unused PHY drivers to reduce image size
• mediatek: Xiaomi AX3000t: fix soft brick for the rd23 model
• mvebu: WD Cloud Mirror Gen2: Add new device
• qualcommax: dl-wrx36: Fix 2.5G port LED-s
• ramips: mt7621: Confiabits MT7621 v1: Add new device
• ramips: mtk_eth_soc: reduce driver memory usage
• realtek: Zyxel GS1900: debounce reset key
• rockchip: disable kernel preemption to increase VPN performance

Generic changes:

• Linux Kernel update to version 6.6.73
• mt76: update to Git HEAD (2025-01-14)
• lldpd: bump version to 1.0.18
• lldpd: fix config for build without LLDP-MED
• hostapd: backport upstream patch to fix setting BSS color
• hostapd: fix processing mbssid config option
• netifd: improve packet steering on ipq40xx (and possibly others)
• wifi-scripts: add macaddr_base wifi-device option
• wifi-scripts: add option to set per-device ifname prefix
• wifi-scripts: allow per-IF mesh basic rate selection

For a detailed list of changes since OpenWrt 24.10.0-rc6 see the 24.10.0-rc6 changelog.

OpenWrt 24.10.0 incorporates over 5300 commits since branching the previous OpenWrt 23.05 release and has been under development for over one year.

• TLS 1.3 support in default images
  • mbedtls was updated to version 3.6 which includes support for TLS 1.3
• Activate POSIX Access Control Lists and file system security attributes for all file systems on devices with big flash sizes. This is needed by docker nowadays.
  • This is activated for all targets which do not have the small_flash feature flag. small_flash is set for the ath79/tiny, bcm47xx/legacy, lantiq/ase, lantiq/xrx200_legacy, lantiq/xway_legacy, ramips/mt76x8, ramips/rt288x, ramips/rt305x and ramips/rt3883 targets.
• Activate kernel support for Multipath TCP on devices with big flash sizes.
• Improved support for WiFi6 (802.11ax) and initial support for WiFi7 (802.11be)
  • Not many Wifi7 devices are supported by OpenWrt yet
• Improved Link Layer Discovery Protocol (LLDP) support
• OpenWrt 24.10 uses OPKG only, APK packages are *not* supported. Only main branch was changed to APK.

OpenWrt 24.10 supports over 1950 devices. Support for over 100 new devices was added in addition to the device support by OpenWrt 23.05.

* Added support for OpenWrt One

• Added d1 target for AllWinner D1 RISC-V SoC
• Added ixp4xx target for Intel XScale IXP4xx SoCs.
• Added loongarch64 target for SoCs with Loongson LoongArch CPUs.
• Added starfive target for StarFive JH71x0 (7100/7110) SoCs.
• Added stm32 target for STMicroelectronics STM32 SoCs.
• Renamed ipq807x target to qualcommax.
• Removed ath25 target. It supported Atheros ieee80211g devices with maximum 16MB RAM
• Removed bcm63xx target. It supported some Broadcom DSL MIPS SoCs and was replaced by the bmips target. The Broadcom DSL itself was never supported.
• Removed octeontx target. It supported the Octeon-TX CN80XX/CN81XX based boards
• Removed oxnas target. It supported the PLXTECH/Oxford NAS782x/OX8xx
• The qoriq target for the NXP QorIQ (PowerPC) SoCs is built
• The ipq806x target for Qualcomm Atheros IPQ806X SoCs was converted to DSA
• Added support for Airoha AN8855 DSA Switch (Xiaomi AX3000T ship both Mediatek and Airoha Switch in the same revision)

Core components have the following versions in 24.10.0:

• Updated toolchain:
  • musl libc 1.2.5
  • glibc 2.38
  • gcc 13.3.0
  • binutils 2.42
• Updated Linux kernel
  • 6.6.73 for all targets
• Network:
  • hostapd master snapshot from September 2024, dnsmasq 2.90, dropbear 2024.86
  • cfg80211/mac80211 from kernel 6.12.6

In addition to the listed applications, many others were also updated.

Sysupgrade can be used to upgrade a device from 23.05 to 24.10, and configuration will be preserved in most cases.

Sysupgrade from 22.03 to 24.10 is not officially supported.

There is no configuration migration path for users of the ipq806x target for Qualcomm Atheros IPQ806X SoCs because it switched to DSA. You have to upgrade without saving the configuration. Image version mismatch. image 1.1 device 1.0 Please wipe config during upgrade (force required) or reinstall. Config cannot be migrated from swconfig to DSA Image check failed

User of the Linksys E8450 aka. Belkin RT3200 running OpenWrt 23.05 or earlier will need to run installer version v1.1.3 or later in order to reorganize the UBI layout for the 24.10 release. A detailed description is in the OpenWrt wiki. Updating without using the installer will break the device. Sysupgrade will show a warning before doing an incompatible upgrade.

Users of the Xiaomi AX3200 aka. Redmi AX6S running OpenWrt 23.05 or earlier have to follow a special upgrade procedure described in the wiki. This will increase the flash memory available for OpenWrt. Updating without following the guide in the wiki break the device. Sysupgrade will show a warning before doing an incompatible upgrade.

Users of Zyxel GS1900 series switches running OpenWrt 23.05 or earlier have to perform a new factory install with the initramfs image due to a changed partition layout. Sysupgrade will show a warning before doing an incompatible upgrade and is not possible.

• LEDs handling for Airoha AN8855 is currently not supported. Xiaomi AX3000T with Airoha Switch mounted will have Switch LEDs powered OFF. (problem will be addressed in later OpenWrt SNAPSHOT and later Openwrt 24.10 minor release)
• 5GHz Wifi on TP-Link Archer C60 v1, TP-Link Archer C6 v2 and probably more devices with ath10k Wifi chip does not work, see https://github.com/openwrt/openwrt/issues/14541
• Ethernet link unstable on some mt7530 switches. Deactivate EEE (Energy-Efficient Ethernet) as a workaround, see: https://github.com/openwrt/openwrt/issues/17351
• 2.5G PHY on Netgear WAX206, Cudy TR3000 and Ruijie RG-X60 Pro broken, see https://github.com/openwrt/openwrt/issues/17183

As always, a big thank you goes to all our active package maintainers, testers, documenters, and supporters.

Have fun!

The OpenWrt Community