Table of Contents
VTech IAD505
Known as 012 Smartbox / Orange Smartbox / Partner Smartbox
This device is not supported yet
Hardware Highlights
Hardware
| CPU | Ram | Flash | Switch | Ethernet | WLAN Hardware | WLAN | USB | Modem | SLIC | POTS | Serial | JTag |
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Lantiq XWAY VRX200 | 128MB | 64MB | Lantiq PHY11G | 4 x 100Mbts | Lantiq XWAY300 x 2* | abgn | 2 x 3.0 | Lantiq XWAY VRX208 | Lantiq XWAY SLIC120 | 2x FXS | Yes |
*1 x 2.4Ghz + 1 x 5Ghz
Info
| Architecture | MIPS |
|---|---|
| Vendor | Lantiq |
| bootloader | U-Boot |
| System-On-Chip | Lantiq XWAY VRX200 |
| CPU/Speed | 34KEc, 500MHz(?) |
| Flash-Chip | Toshiba X8319(TC58DVM92A00(?))* |
| Flash size | 64 MiB |
| Flash type | E2PROM |
| RAM-Chip | EtronTech EM68C16CWVB-25H |
| RAM/Speed | DDR2, 800Mhz(?) |
| RAM size | 128 MiB |
| Wireless | Lantiq XWAY300 (PSB 8221 EL v1.1 + PSB 8231 EL v1.1) |
| Wireless PHYs | 2.4ghz + 5Ghz 802.11abgn 3T3R PCI + PCIe |
| SLIC | Lantiq SLIC120 (PEF 42068 V v1.2) |
| POTS | 2x FXS |
| Ethernet | Lantiq PHY11G (PEF7071 V v1.5) |
| Ethernet PHYs | 4 x 100Mbt |
| Modem | Lantiq XWAY VRX208 (PSB 80190 V v1.1) |
| Internet | VDSL2 |
| USB | Yes, 2 x USB3.0 |
| Serial | Yes |
| JTAG | ? |
*moriel5: The exact model is obscured by a label that is adhered to the IC on my unit, so basing this upon existing picture.
Serial on the top middle, pins are as marked in the left photo, highlighted in red ( ignore soldered on pin headers ). Serial Baud rate is 115200, 8 data bits, 1 stop bit and no parity. Flow control is RTS/CTS.
UBoot requires a password.
Photos
moriel5: I have slightly less blurry pictures that I took, however the lighting is bad, so I'll retake and then upload them.