Write a short, relevant description of the device. Include a technical overview, but avoid marketing buzzwords/useless stuff. Two to four sentences is about right. A picture is good, too. Edit the page to see how to add pictures.
Support for this device is very limited, xDSL is not supported due to proprietary drivers see: Broadcom BCM63xx as is wifi functionality for the same reason Broadcom Wifi
OpenWrt forum thread: https://forum.openwrt.org/viewtopic.php?id=57268
| CPU | Ram | Flash | Network | WLAN | USB | Serial | JTag |
|---|---|---|---|---|---|---|---|
| Broadcom BCM6361 400 MHz | 128 MiB | 16 MiB | 4+1x 10/100/1000 | abgn | 1x | ? | ? |
| Architecture | MIPS |
|---|---|
| Vendor | Broadcom |
| Bootloader | ? |
| System-On-Chip | Broadcom BCM6361 |
| CPU/Speed | 400 MHz |
| Flash-Chip | Macronix MX25L12845EMI-10G |
| Flash size | 16 MiB |
| RAM | 128 MiB |
| Wireless | Broadcom BCM6361 dual band (802.11bgn 2.4 GHz + 802.11an 5 GHz) |
| Ethernet | 4+1x 10/100/1000 |
| USB | 1x |
| Serial | ? |
| JTAG | ? |
Insert photo of front of the casing
Insert photo of back of the casing
Insert photo of backside label
Insert photo of PCB
https://fccid.io/Q87-X3500/Internal-Photos/Internal-Photos-1838086
Steps to open the case:
→ port.serial general information about the serial port, serial port cable, etc.
How to connect to the Serial Port of this specific device:
Insert photo of PCB with markings for serial port
Pinout from left to right, left being the closest to the PCIe port
VCC TX RX GND
| Serial connection parameters for Linksys X3500 | 115200, 8N1 |
|---|
→ port.jtag general information about the JTAG port, JTAG cable, etc.
How to connect to the JTAG Port of this specific device:
Insert photo of PCB with markings for JTAG port
COPY HERE THE BOOTLOG WITH THE ORIGINAL FIRMWARE
COPY HERE THE BOOTLOG ONCE OPENWRT IS INSTALLED AND RUNNING