Orange Pi R1 (H2+)

U-Boot SPL 2017.11 (Apr 08 2018 - 07:27:14) DRAM: U-Boot 2017.11 (Apr 08 2018 - 07:27:14 +0000) Allwinner Technology CPU: Allwinner H3 (SUN8I 1680) Model: Xunlong Orange Pi R1 DRAM: 256 MiB MMC: SUNXI SD/MMC: 0  1  0 switch to partitions #0, OK mmc0 is current device Scanning mmc 0:1... Found U-Boot script /boot.scr reading /boot.scr 377 bytes read in 15 ms (24.4 KiB/s) ## Executing script at 43100000 reading uImage 2612440 bytes read in 155 ms (16.1 MiB/s) 15325 bytes read in 24 ms (623 KiB/s) ## Booting kernel from Legacy Image at 42000000 ... Image Name: ARM OpenWrt Linux-4.14.32 Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 2612376 Bytes = 2.5 MiB Load Address: 40008000 Entry Point: 40008000 Verifying Checksum ... Starting kernel ... [ 0.000000] Booting Linux on physical CPU 0x0 [ 0.000000] Linux version 4.14.32 (buildbot@builds) (gcc version 7.3.0 (OpenWrt GCC 7.3.0 r6646-cb7ac15)) #0 SMP PREEMPT Mon Apr 9 08:43:45 2018 [ 0.000000] CPU: ARMv7 Processor [410fc075] revision 5 (ARMv7), cr=30c5387d [ 0.000000] CPU: div instructions available: patching division code [ 0.000000] CPU: PIPT / VIPT nonaliasing data cache, VIPT aliasing instruction cache 0] clocksource: arch_sys_counter: mask: 0xffffffffffffff max_cycles: 0x588fe9dc0, max_idle_ns: 440795202592 ns [ 0.000006] sched_clock: 56 bits at 24MHz, resolution 41ns, wraps every 4398046511097ns [ 0.000017] Switching to timer-based delay loop, resolution 41ns [ 0.000147] Console: colour dummy device 80x30 [ 0.000178] Calibrating delay loop (skipped), value calculated using timer frequency.. 48.00 BogoMIPS (lpj=240000) [ 0.000191] pid_max: default: 32768 minimum: 301 [ 0.000295] M thread -1, cpu 2, socket 0, mpidr 80000002 [ 0.340692] CPU3: thread -1, cpu 3, socket 0, mpidr 80000003 [ 0.340764] smp: Brought up 1 node, 4 CPUs [ 0.340783] SMP: Total of 4 processors activated (192.00 BogoMIPS). [ 0.340790] CPU: All CPUmetti <giometti@linux.it> [ 0.393475] PTP clock support registered [ 0.393771] Advanced Linux Sound Architecture Driver Initialized. [ 0.394643] clocksource: Switched to clocksource arch_sys_counter [ 0.399701] NET: Registered protocol family 2 [ 0.400302] TCP established hash table entries: 2048 (order: 1, 8192 bytes) [ 0.400334] TCP bind hash table entries: 2048 (order: 2, 16384 bytes) [ 0.400369] TCP: Hash tables configured (established 2048 bind 2048) [ 0.400459] UDP hash table entries: 256 (order: 1, 8192 bytes) [ 0.400495] UDP-Lite hash table entries: 256 (order: 1, 8192 bytes) [ 0.400757] NET: Registered protocol family 1 [ 0.401094] kvm [1]: 8-bit VMID [ 0.401599] kvm [1]: vgic interrupt IRQ16 [ 0.401694] kvm [1]: Hyp mode initialized successfully [ 0.402771] No memory allocated for crashlog [ 0.402884] workingset: timestamp_bits=30 max_order=16 bucket_order=0 [ 0.406951] squashfs: version 4.0 (2009/01/31) Phillip Lougher [ 0.408648] [ 1.504675] sunxi-mmc 1c0f000.mmc: base:0xd0883000 irq:23 [ 1.510702] sunxi-mmc 1c10000.mmc: allocated mmc-pwrseq [ 1.563632] mmc0: host does not support reading read-only switch, assuming write-enable [ 1.575453] mmc0: new high speed SDHC card at address aaaa [ 1.581305] mmcblk0: mmc0:aaaa SU04G 3.69 GiB [ 1.587208] mmcblk0: p1 p2 [ 2.337904] kmodloader: loading kernel modules from /etc/modules-boot.d/* [ 2.384886] kmodloader: done loading kernel modules from /etc/modules-boot.d/* [ 2.396430] init: - preinit - [ 2.756617] Generic PHY 0.1:01: attached PHY driver [Generic PHY] (mii_bus:phy_addr=0.1:01, irq=POLL) [ 2.767315] dwmac-sun8i 1c30000.ethernet eth0: No MAC Management Counters available [ 2.775023] dwmac-sun8i 1c30000.ethernet eth0: PTP not supported by HW Press the [f] key and hit [enter] to enter failsafe mode Press the [1], [2], [3] or [4] key and hit [enter] to select the debug level [ 6.299786] F2FS-fs (loop0): Mounted with checkpoint version = 5ccce295 [ 6.307337] mount_root: switching to f2fs overlay [ 6.418402] urandom-seed: Seeding with /etc/urandom.seed [ 6.447574] procd: - early - [ 6.450527] procd: - watchdog - [ 7.157195] procd: - ubus - Please press Enter to activate this console. [ 7.370272] kmodloader: loading kernel modules from /etc/modules.d/* [ 7.379253] ip6_tables: (C) 2000-2006 Netfilter Core Team [ 7.819716] ip_tables: (C) 2000-2006 Netfilter Core Team [ 8.217347] nf_conntrack version 0.5.0 (4096 buckets, 16384 max) [ 8.439004] usbcore: registered new interface driver r8152 [ 8.454142] xt_time: kernel timezone is -0000 [ 8.647265] PPP generic driver version 2.4.2 [ 8.652504] NET: Registered protocol family 24 [ 11.563833] Generic PHY 0.1:01: attached PHY driver [Generic PHY] (mii_bus:phy_addr=0.1:01, irq=POLL) [ 11.574892] dwmac-sun8i 1c30000.ethernet eth0: No MAC Management Counters available [ 11.582572] dwmac-sun8i 1c30000.ethernet eth0: PTP not supported by HW [ 11.590208] br-lan: port 1(eth0) entered blocking state [ 11.601048] device eth0 entered promiscuous mode [ 11.607351] IPv6: ADDRCONF(NETDEV_UP): br-lan: link is not ready BusyBox v1.28.3 () built-in shell (ash) _______ ________ __ | |.-----.-----.-----.| | | |.----.| |_ | - || _ | -__| || | | || _|| _| |_______|| __|_____|__|__||________||__| |____| root password defined on this device! Use the "passwd" command to set up a new password in order to prevent unauthorized SSH logins. -------------------------------------------------- root@OpenWrt:/#