Meraki MR26

General availability: END of Sale was March 21, 2016.

Supported Versions: Not implemented (since August 29, 2018)

Summary

Meraki MR26 is a wireless access point with the following features:

cloud managed
3×3 MIMO 802.11n, dual-radio 802.11n, up to 900 Mbps
2.4 + 5 GHz dual band, triple radio (third one dedicated to scanning and rogue AP detection)
Gigabit Ethernet port
powered via 802.3af PoE or AC adapter

BCM53015A1KFEBG, Broadcom BCM53015 with with dual-core Cortex-A9 CPU at 800 MHz, 256KB L2 cache, 16-bit DDR2 interface, USB3, integrated switch, GPHYs and packet accelerator
S34ML01G100TF100, S34ML01G1 1 Gb Spansion SLC NAND Flash Memory for Embedded, 1-bit ECC, x8 and x16 I/O, 3V VCC
H5TQ1G63EFR, SK hynix Inc. 1Gb DDR3 SDRAM
2x BCM43431KMLG, BCM43431 802.11n baseband processor
24C64, 64 Kbit serial I²C bus EEPROM
TPS23754, High Power/High Efficiency PoE Interface and DC/DC Controller
NU801, 3 channel 16 bit PWM Constant Current Driver
Optional Power Adapter: 12v, 1.5A, center positive.

Opening the device is pretty straightforward:

Remove the 4 rubber feet with a small flat-head screw-driver. They are just stickers over the screws.
Use a small Philips screwdriver to remove 4 screws
There are 5 plastic tabs (2 on each long side) that need to be pried apart with the flat screw driver or a shim, like a credit card (see the picture). Go slowly!
There is no need to remove the gray plastic cover, but remove the six small screws along the side of the internals (see the picture).
Carefully remove the circuit board cover.
Inside are 3 VERY TIGHT screws that need to be removed to completely pull the circuit board out. They are very easy to strip. Not sure you need to remove them.

Pictures taken from a unit delivered in December 2015.