TP-Link EAP610-Outdoor

Under Construction!
This page is currently under construction. You can edit the article to help completing it.

Write a short, relevant description of the device. Include a technical overview, but avoid marketing buzzwords/useless stuff. Two to four sentences is about right. A picture is good, too. Edit the page to see how to add pictures.

Generic Router

OpenWrt support

Not supported.

Hardware highlights

CPU Ram Flash Network WLAN USB Serial JTag
IPQ6018 64 MiB 512 MiB 1x Gbit bgn/ac/ax No Yes No

Hardware

Info

Architecture EXAMPLE MIPS
Vendor EXAMPLE Ralink
Bootloader EXAMPLE U-Boot
System-On-Chip EXAMPLE Ralink RT3052 - MIPS 24K V4.12
CPU/Speed EXAMPLE 451 MHz
Flash-Chip EXAMPLE unkown
Flash size EXAMPLE 8 MiB
RAM EXAMPLE 64 MiB
Wireless EXAMPLE RT2860v2 2.4GHz 802.11bgn
Ethernet EXAMPLE 10/100 Mbit/s w/ vlan support
Switch EXAMPLE Qualcomm Atheros QCA8337
USB EXAMPLE 1x 2.0
Serial EXAMPLE Yes
JTAG EXAMPLE Not populated

Photos

Insert photo of front of the casing

Insert photo of back of the casing

Insert photo of backside label

Opening the case

The back of the casing is held in place by plastic clips and eight self-tapping screws. Once the screws are removed, gently pry apart the back.

Serial

port.serial general information about the serial port, serial port cable, etc.

There is no level translator on the board. These pins connect directly to the SoC. The serial adapter must use 1.8V signaling!

Serial connection parameters
for TP-Link EAP610-Outdoor
115200, 8N1, 1.8V

JTAG

There is no JTAG connector on the board.

Bootlogs

OEM bootlog

COPY HERE THE BOOTLOG WITH THE ORIGINAL FIRMWARE


OpenWrt bootlog

COPY HERE THE BOOTLOG ONCE OPENWRT IS INSTALLED AND RUNNING


Notes

Tags

How to add tags