Hasivo S1300WP-8XGT-4S-plus 1.02

U-Boot 2011.12.(3.6.8.55120) (Aug 05 2022 - 13:39:06) Board: RTL9310 CPU:1000MHz LX:200MHz DDR:800MHz DRAM: 512 MB SPI-F: MXIC/C22019/MMIO32-4/ModeC 1x32 MB (plr_flash_info @ 83f7b264) Loading 65536B env. variables from offset 0xe0000 Net: Net Initialization Skipped No ethernet found. 0 ## Booting image from partition ... 0 ## Booting kernel from Legacy Image at 81000000 ... Image Name: RTK_SDK Created: 2024-11-22 16:57:38 UTC Image Type: MIPS Linux Kernel Image (lzma compressed) Data Size: 6148004 Bytes = 5.9 MB Load Address: 80000000 Entry Point: 80316980 Verifying Checksum ... OK Uncompressing Kernel Image ... OK Starting kernel ... console [ttyS0] enabled bootconsole [early0] disabled Calibrating delay loop... 663.55 BogoMIPS (lpj=3317760) pid_max: default: 32768 minimum: 301 Mount-cache hash table entries: 1024 (order: 0, 4096 bytes) Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes) SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb TCP established hash table entries: 2048 (order: 1, 8192 bytes) TCP bind hash table entries: 2048 (order: 3, 40960 bytes) TCP: Hash tables configured (established 2048 bind 2048) TCP: reno registered UDP hash table entries: 256 (order: 1, 12288 bytes) UDP-Lite hash table entries: 256 (order: 1, 12288 bytes) futex hash table entries: 256 (order: 0, 7168 bytes) ntfs: driver 2.1.31 [Flags: R/W]. jffs2: version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc. msgmni has been set to 489 random: modprobe urandom read with 1 bits of entropy available io scheduler noop registered io scheduler deadline registered io scheduler cfq registered (default) Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled serial8250: ttyS0 at MMIO 0x0 (irq = 47, base_baud = 12327200) is a 16550A SCSI Media Changer driver v0.25 RTK_SPI_FLASH_MIO driver is bypassed RTK_NORSFG3 driver is used ================================================================= init_luna_nor_spi_map: flash map at 0xb4000000 SPI NOR driver probe... MXIC/C22019/MMIO32-4/ModeC add SPI NOR partition MTD partitions obtained from built-in array Creating 7 MTD partitions on "rtk_norsf_g3": 0x000000000000-0x0000000e0000 : "LOADER" 0x0000000e0000-0x0000000f0000 : "BDINFO" 0x0000000f0000-0x000000100000 : "SYSINFO" 0x000000100000-0x000000200000 : "JFFS2 CFG" 0x000000200000-0x000000300000 : "JFFS2 LOG" 0x000000300000-0x000000a00000 : "RUNTIME" 0x000000a00000-0x000002000000 : "RUNTIME2" ================================================================= ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver rtk_gen1_hcd_cs_init: rtk_gen1_hcd_cs_init()! rtk_gen1_hcd_cs_init: register rtk_gen1_ehci ok! usb_phy_configure_process: usb_phy_configure_process()! rtk_gen1-ehci rtk_gen1-ehci: Realtek On-Chip EHCI Host Controller rtk_gen1-ehci rtk_gen1-ehci: new USB bus registered, assigned bus number 1 rtk_gen1-ehci rtk_gen1-ehci: irq 28, io mem 0x18021000 rtk_gen1-ehci rtk_gen1-ehci: USB 2.0 started, EHCI 1.00 hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver ohci-platform: OHCI generic platform driver usbcore: registered new interface driver uas usbcore: registered new interface driver usb-storage TCP: cubic registered Freeing unused kernel memory: 4836K (80427000 - 808e0000) init started: BusyBox v1.00 (2024.11.22-08:56+0000) multi-call binary Starting pid 26, console : '/etc/rc' RTCORE LKM Insert... TC util init (isr) Starting pid 62, console /dev/ttyS0: '/bin/sh' Decompressing /mnt/switch.tar.gz ... switch switch/kernel switch/kernel/kernel_rtl9311_7v6 switch/kernel/kernel_9301_version.txt switch/kernel/9310-sdk3.6.8 switch/other switch/other/certificate.pem.crt switch/other/private.pem.key switch/other/do_next switch/other/AmazonRootCA1.pem switch/module switch/module/system_gpio.ko switch/module/inos_ifksdk.ko switch/module/i2c-ddm.ko switch/module/reset.ko switch/module/i2c-poe.ko switch/module/i2c-rtc.ko switch/module/i2c-encyt.ko switch/app switch/app/ospf6d switch/app/dropbear switch/app/ripngd switch/app/mstpd switch/app/snmpd switch/app/ripd switch/app/nsm switch/app/lacpd switch/app/webfiles.tar switch/app/ospfd switch/app/bgpd switch/app/dbclient switch/app/imi switch/app/pimd Start to run IFKSDK ... Start to load DDM module ... Start to load PoE module ... Start to load encyt module ... Start to load GPIO module ... Start to load reset module ... Start to load RTC module ... Start to run MSTP ... Start to run LACP ... Start to run RIP ... Start to run RIPNG ... Start to run OSPF ... Start to run OSPF6 ... Start to run BGP ... Start to run PIM-SM ... Layer 3 switch loading ... Start to load configuration ... S1300WP-8XGT-4S+ 6.8.4 Creation date:Mar 25 2025 09:21:12 User Access Verification