Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revisionBoth sides next revision
zh:docs:guide-user:network:wifi:atheroswds [2019/08/22 09:57] – [使用SSH] biajizh:docs:guide-user:network:wifi:atheroswds [2019/08/22 10:06] – [使用SSH] biaji
Line 117: Line 117:
 参阅[[docs:guide-user:network:wifi:encryption|配置无线密码]]以获取更多密码和密钥配置的信息。 参阅[[docs:guide-user:network:wifi:encryption|配置无线密码]]以获取更多密码和密钥配置的信息。
  
-Disconnect the device from the wired network and reboot the device without any wired connection.+将设备由有线网络断开,并在保持没有有线连接的情况下重启。
  
-The device should boot and automatically connect wirelessly to the access point. **Wait until the client bridge device associates with the access point. This can take 1-2 minutes for the association to happen.** Once this has happened, the **wired interface (e.g. eth0)** should succeed in getting a DHCP address through the new wireless bridge connection. Note that the wireless interface itself on the remote client bridge device does not get an IP address as it is now acting as a transparent bridge.+设备重启后将自动连入接入点的无线网络。**客户段网桥设备启动并连入接入点需要花费1-2分钟,需要等待这个过程结束。** 然后,**有线接口(比如eth0**将通过无线桥接连接成功获取DHCP地址。注意,此时远端客户端网桥设备的无线网络自身却不会获取到IP地址,因为它作为透明网桥被使用。
  
-Any //wired devices// connected via Ethernet to the LAN ports on the remote client bridge device should now be transparently bridged into the main network over the wireless link.+通过LAN端口连接至远端客户端网桥设备的//有线设备//此时已经经由无线连接透明网桥至主网络了。
  
 **无线连接,还需最后一步:** **无线连接,还需最后一步:**
  • Last modified: 2019/08/22 10:07
  • by biaji