Search
You can find the results of your search below.
Fulltext results:
- Wi-Fi /etc/config/wireless @zh:docs:guide-user:network:wifi
- nslation is finished)// ====== Wi-Fi /etc/config/wireless ====== 通过UCI配置wireless产生的配置文件位于 **///etc/config/wireless//**. 如果设备有有线以太网端口, 无线wireless默认设置为 **OFF** 状态. 你可以在 ''/etc/config/wireless'' 中打开它,通过将 ''//option disabled '1'//'' 设置为 ''//op... '0'//'' (注释或删除掉该行也可以). ===== 配置节 ===== A typical wireless config file contains at least a pair of: * //wi
- Wifi扩展器、中继器及桥接配置 @zh:docs:guide-user:network:wifi
- connected again to the Wi-Fi extender, go in the wireless networks page, and click on **Scan** button.\\ \... or networks in the vicinity: <code bash> uci set wireless.@wifi-device[0].disabled="0" uci commit wireless wifi </code> * Set the disabled option to 0 (to enable wireless) * Save changed configuration file * Start wi
- 路由器、交换机、网关及NAT @zh:docs:guide-user:network
- 换机或客户端AP ====== | single | 三种用法: \\ [[#openwrt_as_wireless_repeater_wifi_wifi_switch|OpenWrt作为无线中继(Wi-Fi <-> Wi-Fi交换机)]] \\ [[#openwrt_as_wireless_access_point_wifi_wired_switch|OpenWrt作为无线接入点(Wi-... lowing applies: * all variants can handle both wireless and wired clients on the downstream side (i.e. cl... half bridge), this is for you. ===== OpenWrt as wireless repeater (wireless-to-wireless switch) ===== Foll
- 网络基础知识 /etc/config/network @zh:docs:guide-user:base-system
- LAN (TCP and Bridge config) |||||| | "Switch", "Wireless" | VLANs 和 wireless SSIDs | VLAN 2 (eth 0.2) || VLAN 1 (eth 0.1) |||| LEDE 5 | LEDE 2.4 | | "Switch", "Wireless" | 内部网口标签和无线网卡标签| WAN (Interface) || LAN 1 | ... 建议]] 通过配置[[docs:guide-user:network:wifi:basic|UCI wireless 配置]]中的 ''network'' 选项来分配桥接组关系((要桥接无线接口和物理接口,因为无线接
- 使用Atheros和MAC80211 WDS实现无线网桥(无线中继) @zh:docs:guide-user:network:wifi
- 辑[[docs:guide-user:network:wifi:basic|/etc/config/wireless]]文件。在使用中的已有的''wifi-iface''段落,添加一行:''option wds '1... 跟从前一样可以连接至无线接入点并访问因特网。 以下为无线接入点设备上的示例/etc/config/wireless文件: <code> config wifi-device 'radio0' op... option network 'lan' option ssid 'my-wireless-ssid' option encryption 'psk2' option key 'wireless-secret-password' option mode 'ap'
- 无线接入点 / 哑接入点 @zh:docs:guide-user:network:wifi
- 。//所以,在默认安装下,最后您需要检查无线接入点设置,启用无线安全,并在//Network -> Wireless//启用无线网络。 - 点击//保存并启用//按钮。\\ - 用网线连接主路由的LAN插口和... [[docs:guide-user:network:wifi:basic|/etc/config/wireless]] ==== Step 1: Modify the Network ==== Edit ''/... opriate </code> ==== Step 2: Change the existing wireless network ==== Edit ''/etc/config/wireless'', and don't worry about most of it, things that might need chang
- Dnsmasq DHCP 服务器 @zh:docs:guide-user:base-system
- [google>windows 7 create bridge|bridge]] from the wireless and ethernet interfaces on your client * Add ... rface, making your laptop IPv6-disabled when only wireless is up. - Another solution is IPv6 friendly, you... * When you plug the ethernet cable in, disable wireless interface in control panel (power off wireless won't do it). * When you unplug ethernet cable, enable w
- AP 桥接模式 @zh:docs:guide-user:network:wifi
- to extend your existing wired host router to have wireless capabilities. Clients connecting to OpenWRT will ... antage of bridging is that broadcast traffic from Wireless to LAN and vice versa works without further chang... [[docs:guide-user:network:wifi:basic|/etc/config/wireless]] ==== Step 1: Change the LAN interface ==== Ed... intenance. ==== Step 2: Configure and enable the wireless network ==== In ''/etc/config/wireless'', locate
- Wifi Toggle @zh:docs:guide-user:network:wifi
- bin/woggle #!/bin/sh device="wl0" case $(uci get wireless.$device.disabled) in 0) wifi down $de... echo 1 > /proc/diag/led/power uci set wireless.$device.disabled=1 echo "Wifi disabled" ;; 1) uci set wireless.$device.disabled=0 wifi up $device ... OF" > /sbin/woggle-old #!/bin/sh case "$(uci get wireless.@wifi-device[0].disabled)" in 1) uci
- 基于802.11的无线mesh网状网络 @zh:docs:guide-user:network:wifi:mesh
- 进行任何修剪以减小其大小。 ==== 无线网络配置 ==== 编辑 ''/etc/config/wireless'' 并确定: * ''radio0'' 没有设置为 disabled,或者disabled设置... b/master/package/kernel/mac80211/files/lib/netifd/wireless/mac80211.sh|mac80211.sh Source]]: * MP_CONFIG_I... 种新的基于 nl80211 的wireless devices命令行实用配置工具.[[http://wireless.kernel.org/en/users/Documentation/iw#About_iw|mor... good background article]] from CWNP * [[https://wireless.wiki.kernel.org/en/developers/Documentation/ieee8
- 使用LuCI和CLI允许OpenWrt固件 @zh:docs:guide-user:installation
- 3 > /proc/sys/vm/drop_caches </code> * prevent wireless drivers to be loaded at next boot and then reboot... ath9k* rm /etc/modules.d/b43* reboot </code> The wireless drivers, usually take up quite some amount of RAM... nd are not required (unless you are connected via wireless of course ;-)), so an easy way to free up some RA... etc/config/ucitrack etc/config/uhttpd etc/config/wireless etc/dropbear/authorized_keys etc/dropbear/dropbea
- 节省固件空间 @zh:docs:guide-user:additional-software
- ONFIG_PACKAGE_MAC80211_DEBUGFS | Kernel modules / Wireless Drivers / kmod-mac80211 / Export mac80211 interna... ONFIG_PACKAGE_MAC80211_MESH | Kernel modules / Wireless Drivers / kmod-mac80211 / Enable 802.11s mesh sup
- Wi-Fi漫游 @zh:docs:guide-user:network:wifi
- 400|}} 当使用802.11r时,这可以在每个关联请求帧中找到,在''IEEE 802.11 Wireless Management'' -> ''Tagged parameters'' -> ''RSN In... ttps://youtu.be/4Ua2lI6HBhE?&t=24|A talk given at Wireless Lan Professionals Conference 2019 entitled "Effec
- 使用Image Builder @zh:docs:guide-user:additional-software
- iles/etc/config/ scp root@192.168.1.1:/etc/config/wireless files/etc/config/ scp root@192.168.1.1:/etc/confi
- Opkg软件包管理器 @zh:docs:guide-user:additional-software
- horst] is a scanning and analysis tool for 802.11 wireless networks and especially IBSS (ad-hoc) mode and m