ZTE ZXHN H218N

PUT HERE YOUR BOOTLOG

[ 0.000000] Linux version 3.10.10 (dani@x200) (gcc version 4.6.4 (OpenWrt/Linaro GCC 4.6-2013.05 r37960) ) #10 Fri Sep 13 08:55:42 EEST 2013 [ 0.000000] CPU revision is: 00019749 (MIPS 74Kc) [ 0.000000] bcm47xx: using bcma bus [ 0.000000] bcma: bus0: Found chip with id 0x5357, rev 0x02 and package 0x09 [ 0.000000] bcma: bus0: Core 0 found: ChipCommon (manuf 0x4BF, id 0x800, rev 0x26, class 0x0) [ 0.000000] bcma: bus0: Core 3 found: MIPS 74K (manuf 0x4A7, id 0x82C, rev 0x04, class 0x0) [ 0.000000] bcma: bus0: Found rev 9 PMU (capabilities 0x28A42A09) [ 0.000000] bcma: bus0: Found serial flash [ 0.000000] bcma: bus0: Found M25FL128 serial flash (size: 16384KiB, blocksize: 0x10000, blocks: 256) [ 0.000000] bcma: bus0: Early bus registered [ 0.000000] Determined physical RAM map: [ 0.000000] memory: 04000000 @ 00000000 (usable) [ 0.000000] Initrd not found or empty - disabling initrd [ 0.000000] Zone ranges: [ 0.000000] Normal [mem 0x00000000-0x03ffffff] [ 0.000000] Movable zone start for each node [ 0.000000] Early memory node ranges [ 0.000000] node 0: [mem 0x00000000-0x03ffffff] [ 0.000000] On node 0 totalpages: 16384 [ 0.000000] free_area_init_node: node 0, pgdat 802d09d0, node_mem_map 81000000 [ 0.000000] Normal zone: 128 pages used for memmap [ 0.000000] Normal zone: 0 pages reserved [ 0.000000] Normal zone: 16384 pages, LIFO batch:3 [ 0.000000] Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes. [ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes [ 0.000000] pcpu-alloc: s0 r0 d32768 u32768 alloc=1*32768 [ 0.000000] pcpu-alloc: [0] 0 [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256 [ 0.000000] Kernel command line: noinitrd console=ttyS0,115200 [ 0.000000] PID hash table entries: 256 (order: -2, 1024 bytes) [ 0.000000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) [ 0.000000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) [ 0.000000] Writing ErrCtl register=00000000 [ 0.000000] Readback ErrCtl register=00000000 [ 0.000000] Memory: 59956k/65536k available (2390k kernel code, 5580k reserved, 565k data, 1776k init, 0k highmem) [ 0.000000] NR_IRQS:128 [ 0.032000] Calibrating delay loop... 249.34 BogoMIPS (lpj=498688) [ 0.032000] pid_max: default: 32768 minimum: 301 [ 0.032000] Mount-cache hash table entries: 512 [ 0.036000] NET: Registered protocol family 16 [ 0.052000] bio: create slab <bio-0> at 0 [ 0.056000] Switching to clocksource MIPS [ 0.064000] NET: Registered protocol family 2 [ 0.064000] TCP established hash table entries: 512 (order: 0, 4096 bytes) [ 0.064000] TCP bind hash table entries: 512 (order: -1, 2048 bytes) [ 0.064000] TCP: Hash tables configured (established 512 bind 512) [ 0.064000] TCP: reno registered [ 0.064000] UDP hash table entries: 256 (order: 0, 4096 bytes) [ 0.064000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) [ 0.064000] NET: Registered protocol family 1 [ 0.064000] PCI: CLS 0 bytes, default 32 [ 2.236000] bcma: bus0: Core 1 found: IEEE 802.11 (manuf 0x4BF, id 0x812, rev 0x1C, class 0x0) [ 2.236000] bcma: bus0: Core 2 found: GBit MAC (manuf 0x4BF, id 0x82D, rev 0x03, class 0x0) [ 2.236000] bcma: bus0: Core 4 found: USB 2.0 Host (manuf 0x4BF, id 0x819, rev 0x05, class 0x0) [ 2.236000] bcma: bus0: Core 5 found: DDR1/DDR2 Memory Controller (manuf 0x4BF, id 0x82E, rev 0x02, class 0x0) [ 2.236000] bcma: bus0: Core 6 found: I2S (manuf 0x4BF, id 0x834, rev 0x02, class 0x0) [ 2.236000] bcma: bus0: Core 7 found: Internal Memory (manuf 0x4BF, id 0x80E, rev 0x0B, class 0x0) [ 2.240000] can not parse nvram name sb/1/rxpo2g(null) with value 0xff got -34 [ 2.240000] can not parse nvram name sb/1/ag2(null) with value 0xff got -34 [ 2.240000] can not parse nvram name sb/1/ag3(null) with value 0xff got -34 [ 2.260000] bcma: bus0: Using SPROM revision 8 provided by platform. [ 2.260000] bcma: bus0: PMU resource config unknown or not needed for device 0x5357 [ 2.260000] bcma: bus0: Workarounds unknown or not needed for device 0x5357 [ 2.260000] bcma: bus0: Initializing MIPS core... [ 2.260000] bcma: bus0: set_irq: core 0x0812, irq 3 => 3 [ 2.260000] bcma: bus0: set_irq: core 0x082d, irq 4 => 4 [ 2.260000] bcma: bus0: set_irq: core 0x0819, irq 5 => 5 [ 2.260000] bcma: bus0: set_irq: core 0x0800, irq 2 => 2 [ 2.260000] bcma: bus0: set_irq: core 0x0834, irq 2 => 2 [ 2.260000] bcma: bus0: IRQ reconfiguration done [ 2.260000] bcma: core 0x0800, irq : 2(S)* 3 4 5 6 D I [ 2.260000] bcma: core 0x082c, irq : 2(S) 3 4 5 6 D I* [ 2.260000] bcma: core 0x0812, irq : 2(S) 3* 4 5 6 D I [ 2.260000] bcma: core 0x082d, irq : 2(S) 3 4* 5 6 D I [ 2.260000] bcma: core 0x0819, irq : 2(S) 3 4 5* 6 D I [ 2.260000] bcma: core 0x082e, irq : 2(S) 3 4 5 6 D* I [ 2.260000] bcma: core 0x0834, irq : 2(S)* 3 4 5 6 D I [ 2.260000] bcma: core 0x080e, irq : 2(S) 3 4 5 6 D I* [ 2.268000] bcma: bus0: Bus registered [ 2.268000] squashfs: version 4.0 (2009/01/31) Phillip Lougher [ 2.268000] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. [ 2.272000] msgmni has been set to 117 [ 2.272000] io scheduler noop registered [ 2.272000] io scheduler deadline registered (default) [ 2.272000] Serial: 8250/16550 driver, 2 ports, IRQ sharing enabled [ 2.296000] serial8250.0: ttyS0 at MMIO 0xb8000300 (irq = 2) is a U6_16550A [ 2.652000] console [ttyS0] enabled [ 2.908000] 2 bcm47xxpart partitions found on MTD device bcm47xxsflash [ 2.916000] Creating 2 MTD partitions on "bcm47xxsflash": [ 2.920000] 0x000000000000-0x000000ff0000 : "boot" [ 2.928000] 0x000000ff0000-0x000001000000 : "nvram" [ 2.940000] bcm47xx-wdt bcm47xx-wdt.0: BCM47xx Watchdog Timer enabled (30 seconds) [ 2.948000] TCP: cubic registered [ 2.952000] NET: Registered protocol family 17 [ 2.956000] 8021q: 802.1Q VLAN Support v1.8 [ 2.976000] Freeing unused kernel memory: 1776K (802e4000 - 804a0000) [ 3.028000] bgmac bcma0:1: Found PHY addr: 30 (NOREGS) [ 3.032000] bgmac bcma0:1: Failed to parse et_swtype () [ 3.040000] bgmac bcma0:1: TX on ring 0x200 supports unaligned addressing but this feature is not implemented [ 3.052000] bgmac bcma0:1: TX on ring 0x240 supports unaligned addressing but this feature is not implemented [ 3.060000] bgmac bcma0:1: TX on ring 0x280 supports unaligned addressing but this feature is not implemented [ 3.072000] bgmac bcma0:1: TX on ring 0x2C0 supports unaligned addressing but this feature is not implemented [ 3.080000] bgmac bcma0:1: RX on ring 0x200 supports unaligned addressing but this feature is not implemented [ 3.096000] bgmac bcma0:1: Support for Roboswitch not implemented [ 3.104000] libphy: bgmac mii bus: probed [ 3.112000] b53_common: found switch: BCM5325, rev 0 [ 3.120000] (unregistered net_device): attached PHY driver [Broadcom B53 (2)] (mii_bus:phy_addr=bgmac-0-0:1e) [ 3.132000] bgmac: Broadcom 47xx GBit MAC driver loaded [ 3.144000] Found board: "Unknown Board" [ 3.148000] diag: unknown board found, try legacy detect [ 3.152000] diag: please open a ticket at https://dev.openwrt.org and attach the complete nvram [ 3.164000] diag: Router model not detected. [ 3.224000] bgmac bcma0:1: Failed to parse et_swtype () [ 6.472000] bgmac bcma0:1: Failed to parse et_swtype () [ 7.948000] NET: Registered protocol family 10 [ 8.012000] wl: module license 'unspecified' taints kernel. [ 8.016000] Disabling lock debugging due to kernel taint [ 8.108000] wl0: 5.10.56.27 driver failed with code 13 [ 8.112000] The attach callback failed, BCMA probe aborted [ 8.120000] SSB/BCMA glue driver successfully attached [ 8.128000] PPP generic driver version 2.4.2 [ 8.144000] ip_tables: (C) 2000-2006 Netfilter Core Team [ 8.164000] xt_time: kernel timezone is -0000 [ 8.172000] NET: Registered protocol family 24 [ 8.188000] nf_conntrack version 0.5.0 (964 buckets, 3856 max) [ 8.220000] ip6_tables: (C) 2000-2006 Netfilter Core Team [ 8.276000] diag: unknown board found, try legacy detect [ 8.280000] diag: please open a ticket at https://dev.openwrt.org and attach the complete nvram [ 8.292000] diag: Router model not detected. [ 9.928000] bgmac bcma0:1: Failed to parse et_swtype () [ 10.916000] bgmac bcma0:1: Failed to parse et_swtype () [ 10.936000] bgmac bcma0:1: Failed to parse et_swtype () [ 10.948000] device eth0.1 entered promiscuous mode [ 10.956000] device eth0 entered promiscuous mode [ 10.968000] br-lan: port 1(eth0.1) entered forwarding state [ 10.972000] br-lan: port 1(eth0.1) entered forwarding state [ 11.944000] IPv6: ADDRCONF(NETDEV_CHANGE): eth0.1: link becomes ready [ 12.976000] br-lan: port 1(eth0.1) entered forwarding state