Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| toh:ubiquiti:airmaxm [2016/03/03 22:33] – calculated size from hex-byte to dec-kb bigboss | toh:ubiquiti:airmaxm [2022/10/05 15:15] – [Serial] fix spelling of company name beetlrokr | ||
|---|---|---|---|
| Line 16: | Line 16: | ||
| The bullet-m image is the base of the airmax series. | The bullet-m image is the base of the airmax series. | ||
| - | The rocket-m image is the bullet-m with an additionnal usb driver. | + | The rocket-m image is the bullet-m with an additionnal usb driver. |
| The nano-m image is the bullet-m with an additionnal ethernet. | The nano-m image is the bullet-m with an additionnal ethernet. | ||
| Line 43: | Line 43: | ||
| | 4: | cfg | 0x00040000 | | 4: | cfg | 0x00040000 | ||
| | 5: | EEPROM | | 5: | EEPROM | ||
| + | |||
| + | ===== U-boot Versions ===== | ||
| + | |||
| + | Hashes of various u-boot' | ||
| Line 49: | Line 53: | ||
| Power cycle the device while you keep the reset button pushed. Leds will start to blink red and yellow. | Power cycle the device while you keep the reset button pushed. Leds will start to blink red and yellow. | ||
| - | Then tftp the image to 192.168.1.20 following the instructions at the [[:doc:howto: | + | Then tftp the image to 192.168.1.20 following the instructions at the [[docs:guide-user:installation: |
| ===== Remote reset ===== | ===== Remote reset ===== | ||
| Line 58: | Line 62: | ||
| Serial pins are clearly labeled. GND, SOU, SIN, PWR (3.3V). the PWR connection is not needed when plugged in. | Serial pins are clearly labeled. GND, SOU, SIN, PWR (3.3V). the PWR connection is not needed when plugged in. | ||
| - | Serial settings (which also works for other ubiquity | + | Serial settings (which also works for other Ubiquiti |
| '' | '' | ||