Wireless-AC router based on QCA IPQ8064 with 16MB flash and 512MB RAM. Also sporting xDSL support with BCM63168 SOC and a DSP for VoIP POTS interface and DECT.
DSL will not work at all on devices with BCM63xx DSL chipset (due to unavailability of FLOSS driver for Broadcom chips). Consider this when chosing a device to buy, or when deciding to flash OpenWrt on your device because it is listed as supported.
See Broadcom DSL, Unsupported: DSL modem and Broadcom BCM63xx for details.
→ Basic configuration After flashing, proceed with this.
Set up your Internet connection, configure wireless, configure USB port, etc.
The default network configuration is:
LAN & WiFi
LAN ports (1 to 4)
Switch Ports (for VLANs)
Numbers 4-1 are Ports 1-4 as labeled on the unit, number 5 is the Internet (WAN) on the unit, 0 and 6 is the internal connection to the router itself. Don't be fooled: Port 1 on the unit is number 4 when configuring VLANs. vlan0 = eth0.0, vlan1 = eth0.1 and so on.
toh/tp-link/tp-link_archer_vr2600v_v1.txt · Last modified: 2020/07/07 15:12 by tmomas