Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
toh:tp-link:tl-wr802n_v4 [2024/10/14 12:56] – [Installation] frollictoh:tp-link:tl-wr802n_v4 [2024/10/14 12:58] (current) – [Installation] frollic
Line 35: Line 35:
 The only way to flash the image in TL-WR802N v4 is to use tftp recovery mode in U-Boot: The only way to flash the image in TL-WR802N v4 is to use tftp recovery mode in U-Boot:
  
-  - Configure PC with static IP 192.168.0.225/24 **Alternative server IP address that worked for me was 192.168.0.66** 
   - Install a TFTP server application. For Windows "tftp32" works. For Mac "Pumpkin" was the easiest method for me.   - Install a TFTP server application. For Windows "tftp32" works. For Mac "Pumpkin" was the easiest method for me.
 +  - Configure PC with static IP 192.168.0.225/24 **Alternative server IP address that worked for me was 192.168.0.66**
   - Rename ''openwrt-ramips-mt76x8-tplink_tl-wr802n-v4-squashfs-tftp-recovery.bin'' to ''tp_recovery.bin'' and place it in the TFTP server folder.   - Rename ''openwrt-ramips-mt76x8-tplink_tl-wr802n-v4-squashfs-tftp-recovery.bin'' to ''tp_recovery.bin'' and place it in the TFTP server folder.
-  - Connect PC with the LAN port, press the reset button and switch on the router, keeping the button pressed for around 10 sec, until device starts downloading the file. Pumpkin on Mac by default will prompt for approval for the file transfer.+  - Connect PC with the LAN port, press the reset button and switch on the router, keeping the button pressed for around 10 sec, until device starts downloading the file. Pumpkin on Mac by will ask you to approve the file transfer.
   - Router will download file from the server, write it to flash and reboot. The reboot process takes a couple of minutes. The light on the device will cycle through various patterns as it updates.   - Router will download file from the server, write it to flash and reboot. The reboot process takes a couple of minutes. The light on the device will cycle through various patterns as it updates.
   - Once the LED turns solid, the upgrade should have been completed.   - Once the LED turns solid, the upgrade should have been completed.
-  - Configure your client to DHCP client again, and login to the web GUI at 192.168.1.1+  - Configure your client to DHCP client again, and login to the web GUI at 192.168.1.1.
  
 ==== Energy consumption ==== ==== Energy consumption ====
  • Last modified: 2024/10/14 12:56
  • by frollic