TP-Link EAP610-Outdoor
TP-Link EAP610-Outdoor is a high-performance Wi-Fi 6 (AX1800) Access Point designed for both indoor and outdoor deployments.
It offers business-class features, long-range coverage, and high resistance to harsh weather conditions.
support forum: https://forum.openwrt.org/t/tp-link-eap610-outdoor-v1-20-install-problems/231212/66
Supported Versions
v1 and v1.2 are using the same images, even though they're slightly different internally.
Installation
Installation using web UI
The vendor images of this device are packaged in a format that does not match any previous TP-Link formats.
In order for flashing to work from the vendor's web UI, firmware updates need to be packaged in this format.
The tplink-mkimage-2022.py is provided for this purpose.
This script can also analyze vendor images, and extract the required “support” string.
This string is checked by the vendor firmware, and images with a missing or incorrect string are rejected.
Set up the device using the vendor's web UI. After that go to Management→SSH and enable the “SSH Login” checkbox. Select “Save”.
The connect to the machine via SSH:
ssh -o hostkeyalgorithms=ssh-rsa <ip_of_device>
Disable signature verification:
cliclientd stopcs
Rename the “-web-ui-factory” image to something less than 63 characters, maintaining the “.bin” suffix.
* Go to System → Firmware Update.
* Under “New Firmware File”, click “Browse” and select the image
* Select “Update” and confirm by clicking “OK”.
If the update fails, the web UI should show an error message.
Otherwise, the device should reboot into OpenWRT.
Installation using serial
To flash via TFTP, first place the initramfs image on the TFTP server.
On the U-Boot console use:
setenv serverip <IP of TFTP server> setenv ipaddr <IP in same subnet as TFTP server> tftpboot tplink_eap610-outdoor-initramfs-uImage.itb bootm
This should boot OpenWRT, remember device's IP is now 192.168.1.1.
Once booted, flash the sysupgrade.bin image using either webUI or the command line.
Hardware Highlights
Hardware
Photos
Opening the case
The back of the casing is held in place by plastic clips and eight self-tapping screws. Once the screws are removed, gently pry apart the back.
Serial
→ port.serial general information about the serial port, serial port cable, etc.
There is no level translator on the board. These pins connect directly to the SoC. The serial adapter must use 1.8V signaling!
| Serial connection parameters for TP-Link EAP610-Outdoor | 115200, 8N1, 1.8V |
|---|
JTAG
There is no JTAG connector on the board.
Bootlogs
OEM bootlog
COPY HERE THE BOOTLOG WITH THE ORIGINAL FIRMWARE
OpenWrt bootlog
COPY HERE THE BOOTLOG ONCE OPENWRT IS INSTALLED AND RUNNING