User Tools

Site Tools


toh:t-com:spw724vtypb

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
toh:t-com:spw724vtypb [2018/04/16 19:52]
tmomas Tag section + OpenWrt support status section + infobox added
toh:t-com:spw724vtypb [2018/08/16 21:25] (current)
phikappa added serial console info
Line 33: Line 33:
  
 As most of the other Latiq devices, this one has a resistor to set the bootmode, too. The resistor to unsolder is R138. It is on the back of the board under the big shielding. As most of the other Latiq devices, this one has a resistor to set the bootmode, too. The resistor to unsolder is R138. It is on the back of the board under the big shielding.
 +
 +==== Serial ====
 +-> [[docs:​techref:​hardware:​port.serial]] general information about the serial port, serial port cable, etc.
 +
 +J14 is located right to the big holed plate in the front middle of the board
 +Pin 1 is marked by an arrow.
 +
 +^ Pin   ^ use        ^
 +| 4     | GND        |
 +| 3     | RX         |
 +| 2     | TX         |
 +| 1     | Vcc 3.3V   |
 +
 +Serial connection parameters: 115200, 8N1
  
 ===== Tags ===== ===== Tags =====
 [[meta:​tags|How to add tags]] [[meta:​tags|How to add tags]]
 {{tag>​unsupported lantiq vrx288}} {{tag>​unsupported lantiq vrx288}}
toh/t-com/spw724vtypb.1523908336.txt.gz · Last modified: 2018/04/16 19:52 by tmomas