Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revisionBoth sides next revision | ||
| toh:t-com:spw724vtypb [2018/04/16 19:12] – link to media manager adjusted to wiki syntax; double picture removed tmomas | toh:t-com:spw724vtypb [2018/04/16 19:52] – Tag section + OpenWrt support status section + infobox added tmomas | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== T-Com Speedport W724V Typ B ====== | ====== T-Com Speedport W724V Typ B ====== | ||
| - | THIS PAGE IS IN PROGRESS!!!!!!!!! | ||
| + | {{page> | ||
| + | |||
| + | ===== OpenWrt support status ===== | ||
| + | |||
| + | <color red> | ||
| ===== Hardware ===== | ===== Hardware ===== | ||
| Line 17: | Line 21: | ||
| ^ Serial Port | YES | | ^ Serial Port | YES | | ||
| ^ JTAG | ? | | ^ JTAG | ? | | ||
| - | ^ Power | 12 volts 2500 mA | | + | ^ Power | 12 VDC, 2.5 A | |
| ===== Pictures ===== | ===== Pictures ===== | ||
| Line 30: | Line 34: | ||
| As most of the other Latiq devices, this one has a resistor to set the bootmode, too. The resistor to unsolder is R138. It is on the back of the board under the big shielding. | As most of the other Latiq devices, this one has a resistor to set the bootmode, too. The resistor to unsolder is R138. It is on the back of the board under the big shielding. | ||
| - | ===== Status | + | ===== Tags ===== |
| - | Unknown | + | [[meta: |
| + | {{tag> | ||