Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| toh:snr:cpe-me2-lite [2024/12/11 14:24] – [Installation] wertwert4pda | toh:snr:cpe-me2-lite [2024/12/11 14:41] – [OEM easy installation] wertwert4pda | ||
|---|---|---|---|
| Line 103: | Line 103: | ||
| <WRAP BOX> | <WRAP BOX> | ||
| - | FIXME //The instructions below are for Broadcom devices and only serve as an example.// | ||
| - | **//Remove / modify them if they do not apply to this particular device!//** | ||
| - | |||
| This section deals with | This section deals with | ||
| * How you install OpenWrt from a device freshly opened | * How you install OpenWrt from a device freshly opened | ||
| Line 111: | Line 108: | ||
| **Note:** Reset router to factory defaults if it has been previously configured. | **Note:** Reset router to factory defaults if it has been previously configured. | ||
| - | | + | |
| - | * Upload | + | **Flash instruction via WEB (old factory firmware 1.10.x)** |
| - | | + | 1. Boot SNR-CPE-ME2-Lite normally with " |
| - | * Telnet to 192.168.1.1 and set a root password, or browse | + | 2. Access |
| + | 3. Select the OpenWrt sysupgrade image in " | ||
| + | | ||
| + | |||
| + | **Note: For new factory firmware (EasyWRT 2.6.x) need downgrade | ||
| + | |||
| </ | </ | ||