Ruckus VF7111
Note: Following information is based on
Ruckus VF7111 is officially named as “Ruckus 7111 Multimedia Wireless Adapter”. That given device can be paired with Ruckus 5 GHz AP products and that is likely all. Just as its 2.4GHz counterpart, any other 3rd party AP is likely not compatible by “4 WDS” mode it is using to communicate with an AP.
Hardware
- Bootloader: U-Boot 1.1.4.54 (Aug 6 2008 - 18:35:39) GD8(ap83) 1.0.1.2 - built 18:35:39, Aug 6 2008
- CPU: Atheros AR9132, chip is marked as AR9132-BC1E
- CPU Speed: ? Mhz
- Flash size: 16 MB
- RAM: 32 MB
- Wireless Atheros 802.11a/n (AR9106-AL1A)
- Ethernet: 1 port connected to the CPU
- Power: 12V
- Serial: internal (5-pin connector, 3.3V)
- JTAG: ?
This device is an integrated wifi spot designed to be used indoor.
Serial
For the serial there is a 4-pin connector (H4) on board (not directly suitable for usual 5V RS232 port use):
pin #1 = tx pin #2 = nc pin #3 = 3.3V pin #4 = gnd pin #5 = rx 115200 8N1
u-boot
U-Boot 1.1.4.54 (Aug 6 2008 - 18:35:39) GD8(ap83) 1.0.1.2 - built 18:35:39, Aug 6 2008 DRAM: 32 MB Top of RAM usable for U-Boot at: 81ff0000 Reserving 312k for U-Boot at: 81fa0000 Reserving 768k for malloc() at: 81ee0000 Reserving 44 Bytes for Board Info at: 81edffd4 Reserving 36 Bytes for Global Data at: 81edffb0 Reserving 128k for boot params() at: 81ebffb0 Stack Pointer at: 81ebff98 Now running in RAM - U-Boot at: 81fa0000 u-boot-env crc: ok flash size 16MB, sector count = 64 Flash: 16 MB flash_reserved_offset=0xbff80000 flash_end_reserved_bytes=0x80000 board_configuration(0x81f200e8) @ 0xbff80000 v54 mac addr: 00 24 82 24 12 03 In: serial Out: serial Err: serial Net: ag7100_enet_initialize... reset MAC/PHY mask=0x3300... done : cfg1 0xf cfg2 0x7114 eth0: 00:24:82:24:12:03 eth0 up reset MAC/PHY mask=0x1100... done eth0 No Himem Boot Script !!! Checking auto/recovery boot Booting image rcks_wlan.main (1) type:1/1 ... ### main_loop entered: bootdelay=4 ### main_loop: bootcmd="bootlcl rcks_wlan.main " Hit Ctrl-c to stop autoboot: 0
u-boot> version
U-Boot 1.1.4.54 (Aug 6 2008 - 18:35:39)
GD8(ap83) 1.0.1.2 - built 18:35:39, Aug 6 2008
u-boot>
u-boot> bdinfo boot_params = 0x81EBFFB0 memstart = 0x80000000 memsize = 0x02000000 flashstart = 0xBF000000 flashsize = 0x01000000 flashoffset = 0x00033078 ethaddr = 00:24:82:24:12:03 ip_addr = 10.0.0.1 baudrate = 115200 bps u-boot>
u-boot> fsinfo
### filesystem type is JFFS2
Scanning JFFS2 FS: done.
Compression: NONE
frag count: 0
compressed sum: 0
uncompressed sum: 0
Compression: ZERO
frag count: 0
compressed sum: 0
uncompressed sum: 0
Compression: RTIME
frag count: 0
compressed sum: 0
uncompressed sum: 0
Compression: RUBINMIPS
frag count: 0
compressed sum: 0
uncompressed sum: 0
Compression: COPY
frag count: 0
compressed sum: 0
uncompressed sum: 0
Compression: DYNRUBIN
frag count: 0
compressed sum: 0
uncompressed sum: 0
Compression: ZLIB
frag count: 0
compressed sum: 0
uncompressed sum: 0
u-boot>
u-boot> printenv
bootargs=console=ttyS0,115200 rootfstype=squashfs init=/sbin/init
bootdelay=4
baudrate=115200
ethaddr=0x00:0xaa:0xbb:0xcc:0xdd:0xee
mtdids=nor0=ar9100-nor0
mtdparts=mtdparts=ar9100-nor0:256k(u-boot),6912k(rcks_wlan.main),6912k(rcks_wla)
ethact=eth0
serverip=10.0.0.5
ipaddr=10.0.0.1
stdin=serial
stdout=serial
stderr=serial
partition=nor0,0
mtddevnum=0
mtddevname=u-boot
Environment size: 408/262140 bytes
u-boot>
Installing
Yet not known.