Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| toh:qxwlan:e750a [2018/11/05 07:18] – [Installation] zhangsd20 | toh:qxwlan:e750a [2024/02/12 08:58] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 7: | Line 7: | ||
| ===== Supported Versions ===== | ===== Supported Versions ===== | ||
| - | ---- datatable ---- | + | <!-- ToH: { |
| - | cols | + | " |
| - | headers | + | " |
| - | align : c,c,c,c,c,c,c | + | " |
| - | filter | + | " |
| - | ---- | + | " |
| + | | ||
| + | } --> | ||
| ===== Hardware Highlights ===== | ===== Hardware Highlights ===== | ||
| - | ---- datatable ---- | + | <!-- ToH: { |
| - | cols | + | " |
| - | header | + | " |
| - | align : c,c,c,c,c,c,c,c,c,c,c,c,c | + | " |
| - | filter | + | |
| - | ---- | + | " |
| + | | ||
| + | } --> | ||
| ===== Installation ===== | ===== Installation ===== | ||
| - | ---- datatable ---- | + | <!-- ToH: { |
| - | cols | + | " |
| - | headers | + | " |
| - | align : l,c,c | + | " |
| - | filter | + | " |
| - | ---- | + | " |
| + | | ||
| + | } --> | ||
| Flash instruction (using U-Boot CLI and tftp server): | Flash instruction (using U-Boot CLI and tftp server): | ||
| 1. Configure PC with static IP 192.168.1.10 and tftp server. | 1. Configure PC with static IP 192.168.1.10 and tftp server. | ||
| - | 2. Rename " | + | 2. Rename " |
| - | 3. Connect PC with one of RJ45 ports, power up the board and press " | + | in tftp server directory. |
| + | 3. Connect PC with one of RJ45 ports, power up the board and press | ||
| + | " | ||
| 4. Use the following command to update the device to OpenWrt: "run lfw". | 4. Use the following command to update the device to OpenWrt: "run lfw". | ||
| Line 43: | Line 51: | ||
| 1. Configure PC with static IP 192.168.1.xxx(2-254)/ | 1. Configure PC with static IP 192.168.1.xxx(2-254)/ | ||
| 2. Connect PC with one of RJ45 ports, press the reset button, | 2. Connect PC with one of RJ45 ports, press the reset button, | ||
| - | power up the board and keep button pressed for around 6-7 seconds, until LEDs start flashing. | + | power up the board and keep button pressed for around 6-7 seconds, |
| - | 3. Open your browser and enter 192.168.1.1, | + | until LEDs start flashing. |
| + | 3. Open your browser and enter 192.168.1.1, | ||
| + | and click the upgrade button. | ||