Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| toh:netgear:wnr1000_v2 [2019/02/21 16:11] – einhander | toh:netgear:wnr1000_v2 [2020/09/15 21:36] – [Netgear WNR1000 v2] jlpapple | ||
|---|---|---|---|
| Line 3: | Line 3: | ||
| {{section> | {{section> | ||
| - | WNR1000-100PES - very similar to [[toh:netgear:wnr2000|WNR2000v3]] | + | **Note:** Official images are too large as of 17.XX. Use the Community Builds in the forum topic URL below for the latest 17.XX, 18.XX, and 19.XX images. https:// |
| + | WNR1000-100PES - very similar to [[toh: | ||
| + | WNR1000v2 also exists as WNR1000v2h2 - instructions for WNR1000v2 also work for WNR1000v2h2 without modification. | ||
| ===== Supported Versions ===== | ===== Supported Versions ===== | ||
| ---- datatable ---- | ---- datatable ---- | ||
| Line 40: | Line 42: | ||
| -> [[docs: | -> [[docs: | ||
| - | FIXME Please add the installation procedure here. | + | **Note: |
| + | |||
| + | [[https:// | ||
| + | |||
| + | - - - | ||
| I tried web-interface upload of v2.img linked above, router complained 2x about image, using ambiguous language about cause of failure; filename pattern violation, or image content, or checksum.. | I tried web-interface upload of v2.img linked above, router complained 2x about image, using ambiguous language about cause of failure; filename pattern violation, or image content, or checksum.. | ||
| Line 64: | Line 70: | ||
| After boot you can upgrade openwrt to a newer version with sysupgrade. | After boot you can upgrade openwrt to a newer version with sysupgrade. | ||
| - | |||
| ===== Telnet enable ===== | ===== Telnet enable ===== | ||
| Line 84: | Line 89: | ||
| ==== GPIO ==== | ==== GPIO ==== | ||
| - | GPIO LEDs and buttons on this device are connected to either | + | GPIO LEDs and buttons on this device are connected to GPIO controllers on AR7240 SoC and AR9285 wireless chip. |
| Controlled by **AR7240** SoC (18 GPIOs total, LAN LEDs shared with built-in Ethernet switch) : | Controlled by **AR7240** SoC (18 GPIOs total, LAN LEDs shared with built-in Ethernet switch) : | ||
| ^ Type ^ | ^ Type ^ | ||
| | LED | | LED | ||
| - | | LED | + | | LED |
| | LED | | LED | ||
| | LED | | LED | ||
| Line 101: | Line 106: | ||
| | LED | | LED | ||
| - | Controlled by **AR9285** wireless chip (12 GPIOs total, unaccessible with default ath9k driver, see __Patches__ section below) : | + | Controlled by **AR9285** wireless chip (12 GPIOs total) : |
| ^ | ^ | ||
| | | | | ||
| Line 115: | Line 120: | ||
| *//[2] - ' | *//[2] - ' | ||
| *//[3] - this is amber light on power LED (labelled TEST in u-boot sources)// | *//[3] - this is amber light on power LED (labelled TEST in u-boot sources)// | ||
| - | |||
| - | === Patches === | ||
| - | |||
| - | Patches providing full GPIO support on WNR2000v3 / WNR612v2 / WNR1000v2 have been submitted to trunk ([[https:// | ||
| - | All above patches and their versions backported to Chaos Chalmer (15.05) are available at [[https:// | ||
| === GPIO in OpenWrt === | === GPIO in OpenWrt === | ||
| Line 145: | Line 145: | ||
| | | ||
| </ | </ | ||
| + | |||
| + | ===== Custom u-boot ===== | ||
| + | |||
| + | There is a project allowing to build custom u-boot image https:// | ||
| + | It could be used if flash memory chip was replaced or to obtain additional functionality. | ||
| ===== Tags ===== | ===== Tags ===== | ||
| [[meta: | [[meta: | ||
| {{tag> | {{tag> | ||