Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
inbox:toh:netgear:netgear_stora [2020/09/21 06:56] – [Serial] energoblocktoh:netgear:ms2000 [2024/02/22 22:17] (current) – [Opening the case] Removed redundant information and added more details someguy25124
Line 1: Line 1:
-====== Netgear Stora ======+====== NETGEAR Stora ======
  
 ===== OpenWrt support ===== ===== OpenWrt support =====
Line 94: Line 94:
 ==== Photos ==== ==== Photos ====
  
-{{:inbox:toh:netgear:netgear_ms2110_front.jpg?400|}}+{{media:netgear:netgear_ms2110_front.jpg?400|}}
  
-{{:inbox:toh:netgear:netgear_ms2110_back.jpg?400|}}+{{media:netgear:netgear_ms2110_back.jpg?400|}}
  
-{{:inbox:toh:netgear:netgear_ms2110_pcb.jpg?400|}}+{{media:netgear:netgear_ms2110_pcb.jpg?400|}}
  
 ==== Opening the case ==== ==== Opening the case ====
  
-   Remove the front panel upwards (that's where the disks can be inserted) +No force necessary. 
-   * The back panel are not held by screws, it can be popped out if you insert a flat screwdriver from the side + 
-   * The serial port is in the upper area of the PCB+   Slide the front cover upwards (that's where the disks can be inserted) 
 +   * The right side panel can then slide forward while the left remains blocked by the back panel.  
 +   * Remove the top panel by popping the now visible snap fit connectors (front and right side) back out with a flat head screwdriver
 +   * Remove the two screws inside the disk release latches and pop the snap fit connectors (top side) of the back panel.  
 + 
 +   Should the back panel not come off also pop the back panels bottom snap fit connectors (remove bottom panel like top panel). The left side will remain blocked until the back panel is removed. 
 +   * During reassembly it is physically possible to plug the cables connecting the main PCB to the USB/LED PCB in the wrong way. (For my unit its flat side of the plug facing up on both PCBs).  
 + 
  
 ==== Serial ==== ==== Serial ====
Line 473: Line 481:
  
 ===== Notes ===== ===== Notes =====
 +Before compiling the project, be sure to replace the MAC address with the real one for your device. You can find it on a sticker on the back wall, next to the power button. 
 +You need to replace in the file package/boot/uboot-kirkwood/patches/170-netgear-stora.patch on line 597. 
 +If you do not do this and you have two or more Netgear Stora devices on the network with this OpenWRT firmware, then these devices will have network connection problems due to duplication of MAC addresses.
 ===== Tags ===== ===== Tags =====
 [[meta:tags|How to add tags]] [[meta:tags|How to add tags]]
-{{tag>marvell kirkwood 256flash 128ram serial USB2.0 SATA2 GigabitEthernet NAS ARMv5 WiP}}+{{tag>kirkwood 256flash 128ram serial USB2.0 SATA2 GigabitEthernet NAS ARMv5 RTC WiP}}
  
  • Last modified: 2024/02/22 22:17
  • by someguy25124