uBoot Output

This is the output of uBoot via serial console (115200 baud) on a stock (i.e. yet unflashed) Netgear DGN3500: 

ROM VER: 1.1.3
CFG 05

ROM VER: 1.1.3
CFG 05


U-Boot 1.1.5-2.4 (Dec 24 2009 - 15:22:21)

**checkboard **
Boot from SPI
AR9 BOARD
CLOCK CPU 333M RAM 166M
DRAM:  64 MB
spi_init_f finsihed
	 SFLASH_BAUDRATE = 30000000
	 CONFIG_SPI_FLASH_SLOW_READ yes

 relocate_code start
 relocate_code finish.
Flash: 16 MB
  bi_flashstart=00000000
  bi_flashsize=01000000
  bi_flashoffset=00000000
spi_init_f finsihed
	 SFLASH_BAUDRATE = 30000000
	 CONFIG_SPI_FLASH_SLOW_READ yes
In:    serial
Out:   serial
Err:   serial
Net:   
*** amazon_s_sw_chip_init

switch chip id=0000ffff
init 8366 rb
 -The DATA=0x0
The DATA=0x1C
The DATA=0xC961
The DATA=0x1140
smi_init = 0
initChip verid = 0x3
rtl8366rb_initChip= 0
The 0x0=0x830    0
The 0x509=0x5937    0
rtl8368s_setAsicMacForceLink = 0   
rtl8366rb_setLedMode(2, null)=0
amazon_s Switch
board_init_r:
	 PID=YP5726
	 ethaddr=aa:bb:cc:dd:ee:ff
	 serialnumber=.............
	 pin=12345678

Type "run flash_nfs" to mount root filesystem over NFS

Hit any key to stop autoboot:  3  0 
AMAZON_S #

This is the output of uBoot via serial console (115200 baud) on a stock (i.e. yet unflashed) Netgear DGN3500B: 

ROM VER: 1.1.3
CFG 05


U-Boot 1.1.5-2.4 (Oct  4 2010 - 11:56:12)

**checkboard **
Boot from SPI
AR9 BOARD
CLOCK CPU 333M RAM 166M
DRAM:  64 MB
spi_init_f finsihed
         SFLASH_BAUDRATE = 30000000
         CONFIG_SPI_FLASH_SLOW_READ yes

 relocate_code start
 relocate_code finish.
Flash: 16 MB
  bi_flashstart=00000000
  bi_flashsize=01000000
  bi_flashoffset=00000000
spi_init_f finsihed
         SFLASH_BAUDRATE = 30000000
         CONFIG_SPI_FLASH_SLOW_READ yes
In:    serial
Out:   serial
Err:   serial
Net:   
*** amazon_s_sw_chip_init

switch chip id=0000ffff
init 8366 rb
 -The DATA=0x0
The DATA=0x1C
The DATA=0xC961
The DATA=0x1140
smi_init = 0
initChip verid = 0x3
rtl8366rb_initChip= 0
The 0x0=0x830    0
The 0x509=0x5937    0
rtl8368s_setAsicMacForceLink = 0   
rtl8366rb_setLedMode(2, null)=0
amazon_s Switch
board_init_r:
         PID=YP5724
         ethaddr=aa:bb:cc:dd:ee:ff
         serialnumber=.............
         pin=12345678

Type "run flash_nfs" to mount root filesystem over NFS

Hit any key to stop autoboot:  0
AMAZON_S #

Some values in board_init_r have been blanked.

DGN3500 Environment

bootcmd=run flash_flash
bootdelay=3
baudrate=115200
preboot=echo;echo Type "run flash_nfs" to mount root filesystem over NFS;echo
ipaddr=192.168.1.1
serverip=192.168.1.15
netdev=eth0
baudrate=115200
rootpath=/opt/nfs
nfsargs=setenv bootargs root=/dev/nfs rw nfsroot=$(serverip):$(rootpath)
ramargs=setenv bootargs root=/dev/ram rw
addip=setenv bootargs $(bootargs) ip=$(ipaddr):$(serverip):$(gatewayip):$(netmask):$(hostname):$(netdev):on
addmisc=setenv bootargs $(bootargs) console=ttyS1,$(baudrate) ethaddr=$(ethaddr) phym=$(mem) mem=$(mem) panic=1
flash_nfs=run nfsargs addip addmisc;bootm $(kernel_addr)
ramdisk_addr=B0100000
flash_self=run ramargs addip addmisc;bootm $(kernel_addr) $(ramdisk_addr)
img_uboot=u-boot.sflash
img_kernel=uImage
img_dslfw=firmware.img
img_fullimg=fullimage.img
img_rootfs=rootfs.img
net_nfs=tftp 80500000 $(img_kernel);run nfsargs addip addmisc;bootm
net_ram=tftp 80500000 $(img_kernel);run ramargs addip addmisc;bootm
load=tftp 80500000 $(img_uboot)
update=protect off 1:0-2;era 1:0-2;cp.b 80500000 0x0 $(filesize)
flashargs=setenv bootargs root=/dev/mtdblock0
update_uboot=tftpboot 80400000 $(img_uboot);eeprom write 80400000 0 $(filesize); run reset_uboot_config
update_kernel=tftpboot 80400000 $(img_kernel);upgrade 80400000 $(filesize)
update_rootfs=tftpboot 80400000 $(img_rootfs);upgrade 80400000 $(filesize)
update_firmware=tftpboot 80400000 $(img_dslfw);upgrade 80400000 $(filesize)
update_fullimage=tftpboot 80400000 $(img_fullimg);upgrade 80400000 $(filesize)
reset_uboot_config=mw 80400000 'FFFFFFFF' $(f_ubootconfig_size); eeprom write 80400000 $(f_ubootconfig_addr) $(f_ubootconfig_size); reset
reset_system_config=mw 80400000 'FFFFFFFF' $(f_sysconfig_size); eeprom write 80400000 $(f_sysconfig_addr) $(f_sysconfig_size)
part0_begin=0x00000000
part1_begin=0x00010000
part2_begin=0x00040000
total_part=3
flash_end=0x007FFFFF
data_block0=uboot
data_block2=rootfs
data_block3=kernel
data_block5=ubootconfig
total_db=9
f_uboot_addr=0x00000000
f_uboot_size=0
f_uboot_end=0x00010FFF
f_rootfs_addr=0x00180000
f_rootfs_size=0
f_rootfs_end=0x00180000
f_kernel_addr=0x00050000
f_kernel_size=0
f_ubootconfig_addr=0x00010000
f_ubootconfig_size=0x1000
f_calibration_addr=0x00010000
f_calibration_size=0x1000
ethact=amazon_s Switch
mem=64M
flash_flash=run flashargs addip addmisc; bootm $(kernel_addr)
kernel_addr=0x50000
mt_time=0
ethaddr=aa:bb:cc:dd:ee:ff
serialnumber=.............
pin=12345678
stdin=serial
stdout=serial
stderr=serial

Environment size: 2473/4092 bytes

DGN3500B Environment

bootcmd=run flash_flash
bootdelay=3
baudrate=115200
preboot=echo;echo Type "run flash_nfs" to mount root filesystem over NFS;echo
ipaddr=192.168.1.1
serverip=192.168.1.15
netdev=eth0
baudrate=115200
rootpath=/opt/nfs
nfsargs=setenv bootargs root=/dev/nfs rw nfsroot=$(serverip):$(rootpath)
ramargs=setenv bootargs root=/dev/ram rw
addip=setenv bootargs $(bootargs) ip=$(ipaddr):$(serverip):$(gatewayip):$(netmask):$(hostname):$(netdev):on
addmisc=setenv bootargs $(bootargs) console=ttyS1,$(baudrate) ethaddr=$(ethaddr) phym=$(mem) mem=$(mem) panic=1
flash_nfs=run nfsargs addip addmisc;bootm $(kernel_addr)
ramdisk_addr=B0100000
flash_self=run ramargs addip addmisc;bootm $(kernel_addr) $(ramdisk_addr)
img_uboot=u-boot.sflash
img_kernel=uImage
img_dslfw=firmware.img
img_fullimg=fullimage.img
img_rootfs=rootfs.img
net_nfs=tftp 80500000 $(img_kernel);run nfsargs addip addmisc;bootm
net_ram=tftp 80500000 $(img_kernel);run ramargs addip addmisc;bootm
load=tftp 80500000 $(img_uboot)
update=protect off 1:0-2;era 1:0-2;cp.b 80500000 0x0 $(filesize)
flashargs=setenv bootargs root=/dev/mtdblock0
update_uboot=tftpboot 80400000 $(img_uboot);eeprom write 80400000 0 $(filesize); run reset_uboot_config
update_kernel=tftpboot 80400000 $(img_kernel);upgrade 80400000 $(filesize)
update_rootfs=tftpboot 80400000 $(img_rootfs);upgrade 80400000 $(filesize)
update_firmware=tftpboot 80400000 $(img_dslfw);upgrade 80400000 $(filesize)
update_fullimage=tftpboot 80400000 $(img_fullimg);upgrade 80400000 $(filesize)
reset_uboot_config=mw 80400000 'FFFFFFFF' $(f_ubootconfig_size); eeprom write 80400000 $(f_ubootconfig_addr) $(f_ubootconfig_size); reset
reset_system_config=mw 80400000 'FFFFFFFF' $(f_sysconfig_size); eeprom write 80400000 $(f_sysconfig_addr) $(f_sysconfig_size)
part0_begin=0x00000000
part1_begin=0x00010000
part2_begin=0x00040000
total_part=3
flash_end=0x007FFFFF
data_block0=uboot
data_block2=rootfs
data_block3=kernel
data_block5=ubootconfig
total_db=9
f_uboot_addr=0x00000000
f_uboot_size=0
f_uboot_end=0x00010FFF
f_rootfs_addr=0x00180000
f_rootfs_size=0
f_rootfs_end=0x00180000
f_kernel_addr=0x00050000
f_kernel_size=0
f_ubootconfig_addr=0x00010000
f_ubootconfig_size=0x1000
f_calibration_addr=0x00010000
f_calibration_size=0x1000
ethact=amazon_s Switch
mem=64M
flash_flash=run flashargs addip addmisc; bootm $(kernel_addr)
kernel_addr=0x50000
mt_time=0
ethaddr=aa:bb:cc:dd:ee:ff
serialnumber=.............
pin=12345678
stdin=serial
stdout=serial
stderr=serial

Environment size: 2473/4092 bytes

As above, some values have been blanked.

This website uses cookies. By using the website, you agree with storing cookies on your computer. Also you acknowledge that you have read and understand our Privacy Policy. If you do not agree leave the website.More information about cookies
  • Last modified: 2012/11/11 11:39
  • by danielg4