Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
Next revisionBoth sides next revision
toh:mikrotik:rb951ui [2015/03/27 08:27] julianjmtoh:mikrotik:rb951ui [2020/08/19 07:49] – [Supported Versions] tpawlowski_ha
Line 1: Line 1:
 +====== Mikrotik RouterBoard RB951Ui-2HnD ======
  
 +===== Supported Versions =====
 +
 +Warning - Mikrotik has made some changes on the board and recently ordered units are no longer supported. Note: https://forum.openwrt.org/t/mikrotik-rb951ui-2hnd-unsupported-nand/72052
 +
 +
 +
 +---- datatable ----
 +cols    : Brand, Model, Versions, Supported Current Rel, OEM device homepage URL_url, OWrt Forum Topic URL_url, Device Techdata_pageid
 +headers : Brand, Model, Version, Current Release, OEM Info, Forum Topic, Technical Data
 +align   : c,c,c,c,c,c,c
 +filter  : Model=RB951Ui-2HnD
 +----
 +
 +
 +===== Hardware Highlights =====
 +---- datatable ----
 +cols    : Model, Versions, CPU, CPU MHz, Flash MB_mbflashs, RAM MB_mbram, WLAN Hardware, WLAN 2.4GHz, WLAN 5.0GHz, Ethernet 100M ports_, Ethernet Gbit ports_, Modem, USB ports_
 +header  : Model, Version,SoC,CPU MHz,Flash MB,RAM MB,WLAN Hardware,WLAN2.4,WLAN5.0,100M ports,Gbit ports,Modem,USB
 +align   : c,c,c,c,c,c,c,c,c,c,c,c,c
 +filter  : Model=RB951Ui-2HnD
 +----
 +
 +
 +FIXME Conflicting with ToH dataentry -> to be checked
 +^ CPU ^ CPU Speed ^ RAM (MB) ^ NAND (MB) ^ Serial Flash ^ Ethernet Switch ^ PoE port ^ Wireless ^ USB ^ UART ^ JTAG ^
 +| AR9334 | 600 MHz | 128 (2x W9751G6KB-25) | 128 (1x TC58DVG02D5TA00-ND) | MX25L512E | AR7240 (10M/100M) | 1-in 5-out (500mA) | AR9344-DC3A | 1x 2.0 | 1x onboard | 1x onboard |
 +
 +
 +Sister product: [[http://routerboard.com/RB951G-2HnD]] 
 +
 +Please refer to the sister board wiki page [[rb951g_2hnd]] for a description of differences.
 +
 +Warning! As of 04/02/2020 WiFi is *not* working on rev2 hardware. Check this post for updates: [[https://forum.openwrt.org/t/support-for-mikrotik-rb951ui-2hnd-r2/46923]]
 +
 +
 +===== Installation =====
 +---- datatable ----
 +cols    : Model, Versions, Supported Current Rel, Firmware OpenWrt Install URL_url, Firmware OpenWrt Upgrade URL_url, Firmware OEM Stock URL_url
 +headers : Model, Version, Current Release, Firmware OpenWrt Install, Firmware OpenWrt Upgrade, Firmware OEM Stock
 +align   : c,c,c
 +filter  : Model=RB951Ui-2HnD
 +----
 +
 +Please refer to [[toh:mikrotik:common|Common Procedures for Mikrotik RouterBoard Products]].
 +
 +===== Initial setup =====
 +
 +=== Leds ===
 +
 +Instructions for setting up LEDs are from 12/2014, but as for v15.05 it seems to be still neccessary to do this.
 +Anyway, please check first if the LEDs are working as desired (plug devices into ethernet ports, check WLAN activity... etc).
 +
 +Add these lines to /etc/config/system
 +
 +  config led 'act'
 +        option trigger 'netdev'
 +        option mode 'link tx rx'
 +        option sysfs 'rb:green:act'
 +        option name 'ACT'
 +        option dev 'eth1'
 +        option brightness '0'
 +        option default '0'
 +  config led 'p1'
 +        option trigger 'netdev'
 +        option name 'Port_1'
 +        option sysfs 'rb:green:port1'
 +        option dev 'eth0'
 +        option mode 'link tx rx'
 +        option default '0'
 +  config led 'p2'
 +        option trigger 'switch0'
 +        option name 'Port_2'
 +        option sysfs 'rb:green:port2'
 +        option port_mask '0x10'
 +        option default '0'
 +  config led 'p3'
 +        option name 'Port_3'
 +        option sysfs 'rb:green:port3'
 +        option trigger 'switch0'
 +        option port_mask '0x8'
 +        option default '0'
 +  config led 'p4'
 +        option name 'Port_4'
 +        option trigger 'switch0'
 +        option sysfs 'rb:green:port4'
 +        option port_mask '0x4'
 +        option default '0'
 +  config led 'p5'
 +        option name 'Port_5'
 +        option sysfs 'rb:green:port5'
 +        option trigger 'switch0'
 +        option port_mask '0x2'
 +        option default '0'
 +  config led 'wlan'
 +        option sysfs 'rb:green:wlan'
 +        option name 'WLAN'
 +        option trigger 'phy0tpt'
 +        option default '0'
 +
 +There is a red LED on port 5, which seems to be some indication of PoE (same voltage as input [[https://mikrotik.com/product/RB951Ui-2HnD]], so 24 Volts, 0.5 Amp, apparently enabled by default). You can (tested working for v18 and v19 [[https://forum.openwrt.org/t/mikrotik-routerboard-rb951ui-2hnd-frozen-red-led-5th-port/19667/2|in the forum]] ) turn the LED off by editing /etc/config/system:
 +
 +  # Disable PoE on port 5
 +  config gpio_switch 'poe'
 +       option name 'POE'
 +       option value '0'
 +       option gpio_pin '2'
 +
 +Or temporarily with the following command (PoE will continue supplying power over port 5, even without the red LED on **[However, see Note below]** ) . You can put it in /etc/rc.local
 +
 +  echo 0 > /sys/class/gpio/gpio2/value
 +** Note 2018-10-10 **
 +Using OpenWRT 18.06.1, after the above command is issued the red LED turns off //and// PoE power is turned off.
 +
 +=== Built in ethernet switch ===
 +
 +In /etc/config/network, add these lines to enable the built-in ethernet switch between ports 2..5.
 +
 +  config switch 'eth1'
 +        option enable '1'
 +        
 +
 +==== Example VLAN configuration for switch ports ====
 +
 +In /etc/config/network, add these lines to enable the switch, and create 2 vlan interfaces (eth1.11 and eth1.12). The first for ports 5 and 4, and the later for ports 3 and 2. Port 1 on the router is eth0.
 +
 +  config switch 'eth1'
 +        option enable '1'
 +        option enable_vlan '1'
 +  config switch_vlan
 +        option device 'eth1'
 +        option vlan '11'
 +        option vid '11'
 +        option ports '0t 1 2'
 +  config switch_vlan
 +        option device 'eth1'
 +        option vlan '12'
 +        option vid '12'
 +        option ports '0t 3 4'
 +        
 +
 +===== References =====
 +
 +Helpfull info:
 +
 +  * [[http://www.lan23.ru/forum/showthread.php?t=10780]] (HowTo on Russian)
 +  * [[http://www.ericconrad.com/2012/05/installing-openwrt-on-routerboard-750gl.html]]
 +  * [[http://ayufan.eu/projects/openwrt-rb951g/]]
 +  * [[http://openwrt.ayufan.eu/rb951g/]]
 +
 +patchworks.openwrt.org is not working since ~2015, the following URL will not work anymore, but you may be interested in URLs pointing to it for the history of dev. on this routerboard.
 +
 +http://patchwork.openwrt.org/patch/3976/
 +
 +
 +===== Tags =====
 +[[meta:tags|How to add tags]]
 +{{tag>AR9334 128flash 128ram}}
  • Last modified: 2024/02/12 08:58
  • by 127.0.0.1