Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| toh:linksys:wrt160n [2018/02/14 07:21] – [Supported Versions] Spacing fix, adding LEDE build jlouie | toh:linksys:wrt160n [2018/03/03 20:46] – ↷ Links adapted because of a move operation | ||
|---|---|---|---|
| Line 3: | Line 3: | ||
| {{section> | {{section> | ||
| {{section> | {{section> | ||
| - | {{page> | ||
| See https:// | See https:// | ||
| Line 15: | Line 14: | ||
| | WRT160N v1.1 | BCM4703 | BCM4321 | 4MB | 16MB | CSE01 | Q87WRT160N | ? | X (See Below)| ? | ? | | | WRT160N v1.1 | BCM4703 | BCM4321 | 4MB | 16MB | CSE01 | Q87WRT160N | ? | X (See Below)| ? | ? | | ||
| | WRT160N v2.0 | RT2880F | Ralink | 4MB | 16MB | CSE11 | Q87WRT160NV2 | ? | not supported | ? | ? | | | WRT160N v2.0 | RT2880F | Ralink | 4MB | 16MB | CSE11 | Q87WRT160NV2 | ? | not supported | ? | ? | | ||
| - | | WRT160N v3.0 | BCM4716 | ? | + | | WRT160N v3.0 | BCM4716 | BCM4716 |
| ==== V1.1 ==== | ==== V1.1 ==== | ||
| Line 44: | Line 43: | ||
| ===== Installation ===== | ===== Installation ===== | ||
| - | ->[[doc:howto: | + | ->[[docs:guide-user: |
| ==== Flash Layout ==== | ==== Flash Layout ==== | ||
| - | ->[[doc:techref:Flash.Layout]] | + | ->[[docs:techref:flash.layout]] |
| Line 78: | Line 77: | ||
| | **Architecture: | | **Architecture: | ||
| | **Vendor:** | Broadcom | | **Vendor:** | Broadcom | ||
| - | | **Bootloader: | + | | **Bootloader: |
| | **System-On-Chip: | | **System-On-Chip: | ||
| | **CPU/ | | **CPU/ | ||
| Line 138: | Line 137: | ||
| === Serial === | === Serial === | ||
| - | -> [[doc: | + | -> [[docs: |
| JP2/J10 is a 3.3v serial port. Boot messages can be seen if you connect a 3.3v level shifter here and monitor with a serial port. | JP2/J10 is a 3.3v serial port. Boot messages can be seen if you connect a 3.3v level shifter here and monitor with a serial port. | ||
| Line 144: | Line 143: | ||
| DO NOT CONNECT DIRECTLY TO A PC SERIAL PORT. Use a 3.3v TTL level shifter. | DO NOT CONNECT DIRECTLY TO A PC SERIAL PORT. Use a 3.3v TTL level shifter. | ||
| Details at this page: | Details at this page: | ||
| - | * [[doc: | + | * [[docs: |