Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revisionBoth sides next revision
toh:linksys:whw03_v2 [2024/02/12 11:13] – external edit toh:linksys:whw03_v2 [2024/02/23 04:04] – [OEM easy installation] palakis
Line 84: Line 84:
 </WRAP> </WRAP>
  
-  - Open Linksys Web UI - http://192.168.1.1/ca or http://10.65.1.1/ca depending on your setup.+  - Open Linksys Web UI - http://192.168.1.1/ca (or http://10.65.1.1/ca depending on your setup
 +      - On newer firmware versions: open the Web UI, login with Administrator password and click the "CA" link at the bottom right of the page
   - Login with your admin password. The default password can be found on a sticker under the device.   - Login with your admin password. The default password can be found on a sticker under the device.
   - To enter into the support mode, click on the "CA" link and the bottom of the page.   - To enter into the support mode, click on the "CA" link and the bottom of the page.
   - Open the "Connectivity" menu and upload the squash-factory image with the "Choose file" button.   - Open the "Connectivity" menu and upload the squash-factory image with the "Choose file" button.
   - Click start. Ignore all the prompts and warnings by click "yes" in all the popups.   - Click start. Ignore all the prompts and warnings by click "yes" in all the popups.
 +
 +You can also flash new firmware with this alternative procedure, which works even on uninitialized devices:
 +
 +  - Open https://192.168.1.1/fwupdate.html (replace 192.168.1.1 with the actual address of your Velop device)
 +  - Login with username "admin" and your administrator password. On uninitialized devices, the password is "admin"
 +  - Type your administrator password in the "Admin password" field. On uninitialized devices, leave the default value
 +  - In the file picker under that field, upload the squashfs-factory image with the "Browse" button
 +  - Click on "Update" and wait. Once the procedure is complete, the page will show '{"result": "OK"}'
 +
  
 The Wifi radios are turned off by default. To configure the router, you will need to connect your computer to the LAN port of the device. The Wifi radios are turned off by default. To configure the router, you will need to connect your computer to the LAN port of the device.
  • Last modified: 2024/11/04 09:39
  • by pbodq2