User Tools

Site Tools


toh:devolo:devolo_devolo_wifi_pro_1200e

devolo WiFi pro 1200e

The devolo WiFi pro 1200e is a wall mountable access point with:

  • Dual band 2.4 and 5 GHz WiFi (2 × 2 IEEE 802.11ac 866Mbps, 2 × 2 IEEE 802.11n 300Mbps)
  • 2x 1Gbit ethernet ports (with Power over Ethernet support)
  • Kensington Lock

Supported Versions

Hardware Highlights

ModelVersionSoCCPU MHzFlash MBRAM MBWLAN HardwareWLAN2.4WLAN5.0100M portsGbit portsModemUSB
WiFi pro 1200eQualcomm Atheros QCA955872016128Qualcomm Atheros QCA9558, Qualcomm Atheros QCA9880b/g/na/n/ac-2--

Installation

Install OpenWrt (generic explanation)

Set a password for the root user as prompted on first set-up of OEM firmware.

  1. Upload OpenWrt sysupgrade image via SSH to the device. Use /tmp as the destination folder on the device. User is root, password previously set in the web interface.
  2. Install OpenWrt with:
    sysupgrade -n -F /tmp/<openwrt-image-name>

Serial Console

There is a pin header labeled J2 soldered into the board already that you can connect to. Looking at the board, when the reset button is facing up, J2 is located close to the “golden square” in the center of the board, straight below the reset button. It is a 4 pin header aligned vertically with the pins being:

  • VCC 3.3V
  • GND
  • TX (devolo transmits here)
  • bottom: RX (devolo receives here)

Main PCB:

Devolo Wifi Pro 1750e Internal Serial Port

Close-up of serial header::

Devolo Wifi Pro 1750e Internal Serial Port

Tags

This website uses cookies. By using the website, you agree with storing cookies on your computer. Also you acknowledge that you have read and understand our Privacy Policy. If you do not agree leave the website.More information about cookies
toh/devolo/devolo_devolo_wifi_pro_1200e.txt · Last modified: 2019/10/22 18:45 by justinotherguy