This is an old revision of the document!
D-Link DIR-890L A1
The DIR-890L “AC3200 Ultra Wi-Fi Router” was introduced by D-Link in early 2015.
It was soon supported using proprietary Broadcom drivers in DD-WRT but was absent from OpenWrt for a long time. Support for the device is part of the OpenWrt repository since june 2023.
Supported Versions
===== Hardware highlights ===== ^ CPU ^ Ram ^ Flash ^ Network ^ WLAN ^ USB ^ Serial ^ JTag ^ | EXAMPLE RT3052 @ 384 MHz | 64 MiB | 8 MiB | 4x 10/100 | bgn | 1x 2.0 | Yes | ? | ===== Hardware ===== ==== Info ==== ^ Architecture | EXAMPLE MIPS | ^ Vendor | EXAMPLE Ralink | ^ Bootloader | EXAMPLE U-Boot | ^ System-On-Chip | EXAMPLE Ralink RT3052 - MIPS 24K V4.12 | ^ CPU/Speed | EXAMPLE 451 MHz | ^ Flash-Chip | EXAMPLE unkown | ^ Flash size | EXAMPLE 8 MiB | ^ RAM | EXAMPLE 64 MiB | ^ Wireless | EXAMPLE RT2860v2 2.4GHz 802.11bgn | ^ Ethernet | EXAMPLE 10/100 Mbit/s w/ vlan support | ^ Switch | EXAMPLE Qualcomm Atheros QCA8337 | ^ USB | EXAMPLE 1x 2.0 | ^ Serial | EXAMPLE Yes | ^ JTAG | EXAMPLE Not populated | ==== Photos ==== Insert photo of front of the casing Insert photo of back of the casing Insert photo of backside label Insert photo of PCB ==== Opening the case ====
Describe what needs to be done to open the device, e.g. remove rubber feet, adhesive labels, screws, ...
==== Serial ====
→ port.serial general information about the serial port, serial port cable, etc.
How to connect to the Serial Port of this specific device:
Insert photo of PCB with markings for serial port
Replace EXAMPLE by real values.
^ Serial connection parameters
for D-Link DIR-890L A1 | EXAMPLE 115200, 8N1, 3.3V |
==== JTAG ====
→ port.jtag general information about the JTAG port, JTAG cable, etc.
How to connect to the JTAG Port of this specific device:
Insert photo of PCB with markings for JTAG port
===== Bootlogs =====
==== OEM bootlog ====
COPY HERE THE BOOTLOG WITH THE ORIGINAL FIRMWARE
==== OpenWrt bootlog ====
COPY HERE THE BOOTLOG ONCE OPENWRT IS INSTALLED AND RUNNING
===== Notes =====
===== Tags =====
How to add tags
