Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revisionBoth sides next revision | ||
| toh:d-link:dir-853_a1 [2024/02/13 04:59] – [Upgrading OpenWrt] rikka0w0 | toh:d-link:dir-853_a1 [2024/02/13 05:05] – [Hardware mods] rikka0w0 | ||
|---|---|---|---|
| Line 200: | Line 200: | ||
| ===== Hardware mods ===== | ===== Hardware mods ===== | ||
| - | None so far. | + | **Not verified!** |
| + | |||
| + | There is an unpopulated USB 2.0 port on the PCB. To use it, you need to short circuit R31, LB15, R35, R38, and R37 on the PCB: | ||
| + | |||
| + | {{media: | ||
| + | |||
| + | The pin out of the USB socket (from the top to bottom) is: | ||
| + | - Vcc, 5V | ||
| + | - D- | ||
| + | - D+ | ||
| + | - GND | ||
| + | |||
| + | This port should work on the official OpenWrt firmware, as '' | ||