Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| toh:d-link:dir-853_a1 [2024/02/13 04:57] – [Specific Configuration] rikka0w0 | toh:d-link:dir-853_a1 [2024/02/13 05:05] – [Hardware mods] rikka0w0 | ||
|---|---|---|---|
| Line 138: | Line 138: | ||
| -> [[docs: | -> [[docs: | ||
| - | <WRAP BOX> | + | Both LuCI web upgrade |
| - | + | ||
| - | FIXME These are generic instructions. Update with your router' | + | |
| - | + | ||
| - | ==== LuCI Web Upgrade Process ==== | + | |
| - | + | ||
| - | * Browse to ''< | + | |
| - | * Upload image file for sysupgrade to LuCI | + | |
| - | * Wait for reboot | + | |
| - | + | ||
| - | ==== Terminal Upgrade Process ==== | + | |
| - | + | ||
| - | If you don't have a GUI (LuCI) available, you can alternatively | + | |
| - | There are two command line methods for upgrading: | + | |
| - | + | ||
| - | * '' | + | |
| - | * '' | + | |
| - | + | ||
| - | Note: It is important that you put the firmware image into the ramdisk (/tmp) before you start flashing. | + | |
| - | + | ||
| - | === sysupgrade === | + | |
| - | + | ||
| - | * Login as root via SSH on 192.168.1.1, | + | |
| - | + | ||
| - | < | + | |
| - | cd /tmp | + | |
| - | wget http:// | + | |
| - | sysupgrade / | + | |
| - | </ | + | |
| - | + | ||
| - | === mtd === | + | |
| - | + | ||
| - | If '' | + | |
| - | + | ||
| - | * Login as root via SSH on 192.168.1.1, | + | |
| - | + | ||
| - | < | + | |
| - | cd /tmp | + | |
| - | wget http:// | + | |
| - | mtd write /tmp/xxx.abc linux && reboot | + | |
| - | </ | + | |
| - | + | ||
| - | </ | + | |
| ===== Failsafe mode ===== | ===== Failsafe mode ===== | ||
| Line 243: | Line 200: | ||
| ===== Hardware mods ===== | ===== Hardware mods ===== | ||
| - | None so far. | + | **Not verified!** |
| + | |||
| + | There is an unpopulated USB 2.0 port on the PCB. To use it, you need to short circuit R31, LB15, R35, R38, and R37 on the PCB: | ||
| + | |||
| + | {{media: | ||
| + | |||
| + | The pin out of the USB socket (from the top to bottom) is: | ||
| + | - Vcc, 5V | ||
| + | - D- | ||
| + | - D+ | ||
| + | - GND | ||
| + | |||
| + | This port should work on the official OpenWrt firmware, as '' | ||