Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revisionBoth sides next revision
toh:d-link:d-link_dap-2680_a1 [2021/01/24 18:48] – [Flash Layout] s_2toh:d-link:d-link_dap-2680_a1 [2021/01/24 18:53] – [Buttons] s_2
Line 149: Line 149:
 Set up your Internet connection, configure wireless, configure USB port, etc. Set up your Internet connection, configure wireless, configure USB port, etc.
  
-===== Specific Configuration ===== 
  
-<WRAP BOX> 
-FIXME Please fill in real values for this device, then remove the EXAMPLEs 
  
-==== Network interfaces ==== 
-The default network configuration is: 
-^ Interface Name   ^ Description                  ^ Default configuration    ^ 
-| br-lan           | EXAMPLE LAN & WiFi           | EXAMPLE 192.168.1.1/24   | 
-| vlan0 (eth0.0)   | EXAMPLE LAN ports (1 to 4)   | EXAMPLE None             | 
-| vlan1 (eth0.1)   | EXAMPLE WAN port             | EXAMPLE DHCP             | 
-| wl0              | EXAMPLE WiFi                 | EXAMPLE Disabled         | 
  
-</WRAP>+==== Buttons ====
  
-==== Switch Ports (for VLANs) ==== +The D-Link DAP-2680 has the following buttons:
-<WRAP BOX> +
-FIXME Please fill in real values for this device, then remove the EXAMPLEs+
  
-Numbers 0-3 are Ports 1-4 as labeled on the unit, number 4 is the Internet (WAN) on the unit, 5 is the internal connection to the router itself. Don't be fooled: Port 1 on the unit is number 3 when configuring VLANs. vlan0 = eth0.0, vlan1 = eth0.1 and so on. +BUTTON GPIO 
-Port             Switch port   +Reset   18  |
-Internet (WAN)   | EXAMPLE 4     | +
-| LAN 1            | EXAMPLE 3     | +
-| LAN 2            | EXAMPLE 2     | +
-| LAN 3            | EXAMPLE 1     | +
-| LAN 4            EXAMPLE 0     |+
  
-</WRAP> 
- 
-==== Buttons ==== 
 -> [[docs:guide-user:hardware:hardware.button]] on howto use and configure the hardware button(s). -> [[docs:guide-user:hardware:hardware.button]] on howto use and configure the hardware button(s).
-Here, we merely name the buttons, so we can use them in the above Howto. 
  
-<WRAP BOX> 
-FIXME Please fill in real values for this device, then remove the EXAMPLEs 
- 
-The D-Link DAP-2680 has the following buttons: 
  
-^ BUTTON                       ^ Event   ^ +==== LEDs ====
-| EXAMPLE Reset                |  reset  | +
-| EXAMPLE Secure Easy Setup    |   ses   | +
-| EXAMPLE No buttons at all.      -    |+
  
-</WRAP>+^ LED ^ GPIO ^ 
 +| power green  |  19  | 
 +| power red  |  20  |
  
 ===== Hardware ===== ===== Hardware =====
  • Last modified: 2024/02/12 11:13
  • by 127.0.0.1