Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revisionBoth sides next revision | ||
| toh:compex:wp543ahv [2016/02/25 09:52] – [Hardware info] dangh | toh:compex:wp543ahv [2018/05/11 09:41] – Datatables added, cleanup tmomas | ||
|---|---|---|---|
| Line 3: | Line 3: | ||
| The device is supported in OpenWrt since Kamikaze 8.09. | The device is supported in OpenWrt since Kamikaze 8.09. | ||
| - | ===== Hardware info ===== | + | ===== Supported Versions |
| - | ^ Architecture | MIPS | | + | ---- datatable ---- |
| - | ^ Vendor | Atheros | | + | cols : Brand, Model, Versions, Supported Current Rel, OEM device homepage URL_url, OWrt Forum Topic URL_url, Device Techdata_pageid |
| - | ^ Bootloader | CFE | | + | headers : Brand, Model, Version, Current Release, OEM Info, Forum Topic, Technical Data |
| - | ^ System-On-Chip | AR7161 | | + | align : c, |
| - | ^ CPU Speed | 680 Mhz | | + | filter |
| - | ^ Flash size | 8 MB (up to 16 MB)| | + | ---- |
| - | ^ RAM | 32 MB (Max 64 MB) DDR SDRAM | | + | |
| - | ^ Wireless | 2 × MiniPCI slots, support all Compex MiniPCI cards | | + | |
| - | ^ Ethernet | + | ===== Hardware Highlights ===== |
| - | ^ USB | 2 × USB 2.0 ports (optional) | | + | ---- datatable ---- |
| - | ^ Serial | yes | | + | cols : Model, Versions, CPU, CPU MHz, Flash MB_mbflashs, |
| - | ^ JTAG | yes | | + | header |
| + | align : c, | ||
| + | filter | ||
| + | ---- | ||
| ===== Installation ===== | ===== Installation ===== | ||
| + | ---- datatable ---- | ||
| + | cols : Model, Versions, Supported Current Rel, Firmware OpenWrt Install URL_url, Firmware OpenWrt Upgrade URL_url, Firmware OEM Stock URL_url | ||
| + | headers : Model, Version, Current Release, Firmware OpenWrt Install, Firmware OpenWrt Upgrade, Firmware OEM Stock | ||
| + | align : l,c,c | ||
| + | filter | ||
| + | ---- | ||
| + | |||
| + | -> [[docs: | ||
| + | |||
| ==== Restore mode ==== | ==== Restore mode ==== | ||
| Line 42: | Line 55: | ||
| Diagnostic LED will now stop blinking for a while; if the flashing procedure is successfully done, it will start blinking slowly. Now reboot your router manually (turn off - turn on) and OpenWrt will boot. | Diagnostic LED will now stop blinking for a while; if the flashing procedure is successfully done, it will start blinking slowly. Now reboot your router manually (turn off - turn on) and OpenWrt will boot. | ||
| - | ===== Upgrading | + | ===== Upgrading |
| === Minimum Requirement === | === Minimum Requirement === | ||
| - | - Compex loader version 2.54 or above. | + | - Compex loader version 2.54 or above. |
| - | - OpenWRT | + | - OpenWrt |
| - | - Please ensure that the Ethernet connection is able to ping address = 192.168.168.1 | + | - Please ensure that the Ethernet connection is able to ping address = 192.168.168.1 |
| - | - If there is a USB NAND flash available on board, you would need to change the loader configuration. Please refer to “what to do if there is a onboard NAND Flash”. | + | - If there is a USB NAND flash available on board, you would need to change the loader configuration. Please refer to “what to do if there is a onboard NAND Flash”. |
| - | === Compiling | + | === Compiling |
| - | - Getting source codes <code bash> | + | - Getting source codes <code bash> |
| $ svn co -r 12448 https:// | $ svn co -r 12448 https:// | ||
| - | - Apply patches from the files mod-wp543.tgz (< | + | - Apply patches from the files mod-wp543.tgz (< |
| $ tar -zxvf mod-wp543.tgz | $ tar -zxvf mod-wp543.tgz | ||
| $ cp -a mod-wp543/* trunk/</ | $ cp -a mod-wp543/* trunk/</ | ||
| - | - Compile< | + | - Compile< |
| $ cd trunk | $ cd trunk | ||
| $ cp wp543.config .config | $ cp wp543.config .config | ||
| $ make</ | $ make</ | ||
| - | OpenWRT | + | OpenWrt |
| + | |||
| + | === Uploading the OpenWrt firmware to WP543 running MyLoader v2.54.0717 === | ||
| + | |||
| + | a. Via Compex Firmware | ||
| + | * Put the AP in Firmware Upgrade mode and upload the file. | ||
| + | * This file is for WP543 with 4MB or 8MB NOR flash. | ||
| + | b. Via TFTP | ||
| + | * Go to the firmware upgrade mode (By pressing and hold the Reset button and plug-in the power adapter). | ||
| + | * Upload the OpenWrt image to the device (//$// **tftp -i 192.168.168.1 put openwrt-ar71xx-wp543.bin**) | ||
| + | |||
| + | |||
| + | ===== Hardware info ===== | ||
| + | ^ Architecture | ||
| + | ^ Vendor | ||
| + | ^ Bootloader | ||
| + | ^ System-On-Chip | ||
| + | ^ CPU Speed | 680 Mhz | | ||
| + | ^ Flash size | 8 MB (up to 16 MB) | | ||
| + | ^ RAM | 32 MB (Max 64 MB) DDR SDRAM | | ||
| + | ^ Wireless | ||
| + | ^ Ethernet | ||
| + | ^ USB | 2 × USB 2.0 ports (optional) | ||
| + | ^ Serial | ||
| + | ^ JTAG | yes | | ||
| - | === Uploading the OpenWRT firmware to WP543 running MyLoader v2.54.0717 === | ||
| - | a. Via Compex Firmware | ||
| - | *Put the AP in Firmware Upgrade mode and upload the file. | ||
| - | *This file is for WP543 with 4MB or 8MB NOR flash. | ||
| - | b. Via TFTP | ||
| - | *Go to the firmware upgrade mode (By pressing and hold the Reset button and plug-in the power adapter). | ||
| - | *Upload the OpenWRT image to the device (//$// **tftp -i 192.168.168.1 put openwrt-ar71xx-wp543.bin**) | ||
| ===== Wireless ===== | ===== Wireless ===== | ||
| Line 87: | Line 117: | ||
| ===== Tags ===== | ===== Tags ===== | ||
| [[meta: | [[meta: | ||
| - | {{tag> | + | {{tag> |