The device is supported in OpenWrt since Kamikaze 8.09.
|Model||Version||Current Release||Firmware OpenWrt Install||Firmware OpenWrt Upgrade||Firmware OEM Stock|
If you want to upload firmware to router by tftp, you will have to turn your device to this mode. The procedure is following:
Set your ethernet interface into static mode (IP address 192.168.168.10, netmask 255.255.255.0, default gateway 192.168.168.1), put your router into Restore mode and upload the firmware by TFTP using the following commands (replace XXXXXX with wp543):
$ tftp 192.168.168.1 tftp> binary tftp> trace tftp> put openwrt-ar71xx-wp543.bin
Diagnostic LED will now stop blinking for a while; if the flashing procedure is successfully done, it will start blinking slowly. Now reboot your router manually (turn off - turn on) and OpenWrt will boot.
$ svn co -r 12448 https://snv.openwrt.org/openwrt/trunk
$ tar -zxvf mod-wp543.tgz $ cp -a mod-wp543/* trunk/
$ cd trunk $ cp wp543.config .config $ make
OpenWrt Firmware will be in bin/openwrt-ar71xx-wp543.bin
a. Via Compex Firmware
b. Via TFTP
|CPU Speed||300 Mhz|
|Flash size||4 MB (up to 16 MB)|
|RAM||32 MB (Max 64 MB) DDR SDRAM|
|Wireless||1 × 9.2mm MiniPCI slot , support all Compex MiniPCI cards|
|Ethernet||1 × 10/100 Base-TX Ethernet Port (with Auto MDI/MDIX)|
|USB||2 × USB 2.0 ports (optional)|
Both madwifi and ath9k work well with all Compex MiniPCI cards. You will need some wireless authenticator and/or supplicant (wpad-mini/wpad/wpa-supplicant/hostpad/hostapd-mini).
Madwifi doesn't support MAC changes through UCI on this architecture. If you want to change of wireless MAC, see this.
This page has been assembled from a number of different pages from the old wiki and the current wiki. Refer to them for more (possibly outdated) information.