|Incomplete This article is not yet written. This is just the standard template. Do not consult this article|
Buffalo BroadStation BHR-4RV router w/ 4-port AUTO-MDIX switch, the board is identical to WZR-RS-G54, only without the WiFi.
|BroadCom BCM4704KPBG||8MiB||32MiB||4 x 1||No||Yes||?|
Please check out the article flash.layout. It contains an example and a couple of explanations.
This section deals with how you install OpenWrt from a device freshly opened. Plus the steps required such as reset to factory defaults if the device has already been configured
Note: Reset router to factory defaults if it has been previously configured.
If you want to upgrade using TFTP you follow these steps (as an alternative to the above install process.
If you have already installed OpenWrt and like to reflash for e.g. upgrading to a new OpenWrt version you can upgrade using the mtd command line tool. It is important that you put the firmware image into the ramdisk (/tmp) before you start flashing.
cd /tmp/ wget http://downloads.openwrt.org/snapshots/trunk/XXX/xxx.abc sysupgrade /tmp/xxx.abc
cd /tmp/ wget http://downloads.openwrt.org/snapshots/trunk/XXX/xxx.abc mtd write /tmp/xxx.abc linux && reboot
→ Basic configuration After flashing, proceed with this.
Set up your Internet connection, configure wireless, configure USB port, etc.
The default network configuration is:
|Interface Name||Description||Default configuration|
|br-lan||LAN & WiFi||192.168.1.1/24|
|vlan0 (eth0.0)||LAN ports (1 to 4)||None|
|vlan1 (eth0.1)||WAN port||DHCP|
Numbers 0-3 are Ports 1-4 as labeled on the unit, number 4 is the Internet (WAN) on the unit, 5 is the internal connection to the router itself. Don't be fooled: Port 1 on the unit is number 3 when configuring VLANs. vlan0 = eth0.0, vlan1 = eth0.1 and so on.
→ hardware.button on howto use and configure the hardware button(s).
The Linksys WRT54GL has two buttons. They are Reset and Secure Easy Setup. Here, we merely name the buttons, so we can use them in the above Howto:
|Secure Easy Setup||ses|
|Architecture:||MIPS / ARM / AVR32 / ETRAX CRIS / 68000 / PowerPC / SPARC / Ubicom32 / SuperH / x86|
|Vendor:||Qualcomm Atheros / Broadcom / Ikanos / Lantiq / Marvell / Ralink / …|
|bootloader:||U-Boot / redboot / …|
|System-On-Chip:||AR9132 rev 2 (MIPS 24Kc V7.4)|
|CPU/Speed||24Kc V7.4 400 Mhz|
|Flash size:||8192 KiB|
|Wireless:||Atheros AR9103 2.4ghz 802.11bgn|
|Ethernet:||RealTek RTL8366RB Gigabit w/ vlan support swconfig|
|USB:||Yes 1 x 2.0|
Photo of front of the casing
Photo of back of the casing
Note: This will void your warranty!
Photo of PCB
→ port.serial general information about the serial port, serial port cable, etc.
How to connect to the Serial Port of this specific device:
Photo of PCB with markings
→ port.jtag general information about the JTAG port, JTAG cable, etc.
How to connect to the JTAG Port of this specific device:
Photo of PCB with markings