Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revisionBoth sides next revision
inbox:toh:beeline:smartbox_pro [2023/07/03 15:58] – [JTAG] csharper2005toh:beeline:smartbox_pro [2023/07/15 13:36] – [sercomm-recovery utility] csharper2005
Line 97: Line 97:
 2. Connect the router with a cable and run sercomm-recovery: 2. Connect the router with a cable and run sercomm-recovery:
 <code bash> <code bash>
-sudo ./sercomm-recovery enp0s3 recovery_wifire-s1500.nbn_1st-v2.0.12_2nd-v2.0.14.bin+sudo ./sercomm-recovery enp0s3 recovery.bin
 </code> </code>
 where: where:
   * //enp0s3// - network interface connected the router   * //enp0s3// - network interface connected the router
   * //ifconfig// - list on available network interfaces   * //ifconfig// - list on available network interfaces
-  * //recovery_wifire-s1500.nbn_1st-v2.0.12_2nd-v2.0.14.bin// - recovery image with the //Sercomm1// bootflag activated+  * //recovery.bin// - recovery image
    
 3. Wait until the router is flashed and rebooted. 3. Wait until the router is flashed and rebooted.
Line 302: Line 302:
 </a2s> </a2s>
  
-==== Restoring the original U-boot bootloader and stock firmware  ====+===== Restoring the original U-boot bootloader and stock firmware  =====
  
 {{page>meta:infobox:dangerous&noheader&nofooter&noeditbtn}} {{page>meta:infobox:dangerous&noheader&nofooter&noeditbtn}}
Line 355: Line 355:
 </code> </code>
  
-5. Use sercomm-recovery_utility utility for stock firmware recovery+5. Use sercomm-recovery utility for stock firmware recovery
  
 ===== Bootlogs ===== ===== Bootlogs =====
  • Last modified: 2024/09/05 19:05
  • by csharper2005