Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| toh:asus:rp-n53 [2021/07/16 10:32] – [Tags] danitool | toh:asus:rp-n53 [2023/03/22 02:29] – [Installation process (Windows)] theman | ||
|---|---|---|---|
| Line 24: | Line 24: | ||
| filter | filter | ||
| ---- | ---- | ||
| + | |||
| + | Use the Asus Recovery Utility. No disassembly or soldering necessary. | ||
| + | |||
| + | Open the utility on a Windows computer. Point to the OpenWrt sysupgrade file. Connect the unit with an ethernet cable directly to the computer. Plug the unit in the wall while holding the reset button. Release the button when the "led bar" light up (or blink). The flashing process then starts. You can do the same to revert to the Asus firmware. | ||
| + | |||
| + | |||
| + | |||
| + | ==== Alternative Installation process (Windows) ==== | ||
| To install OpenWrt on RP-N53 you need : | To install OpenWrt on RP-N53 you need : | ||
| Line 29: | Line 37: | ||
| - Soldering iron | - Soldering iron | ||
| - USB to UART converter | - USB to UART converter | ||
| - | + | {{page> | |
| - | ==== Installation process (Windows): ==== | + | |
| - First of all you need to disassemble RP-N53. There is 1 screw under the sticker on the back and latches around the perimeter of the cover. | - First of all you need to disassemble RP-N53. There is 1 screw under the sticker on the back and latches around the perimeter of the cover. | ||
| Line 63: | Line 69: | ||
| ===== Tags ===== | ===== Tags ===== | ||
| [[meta: | [[meta: | ||
| - | {{tag> | + | {{tag> |