Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| toh:asmax:ar_1004g [2015/05/03 10:53] – [Software] link to 14.07 FW image added tmomas | toh:asmax:ar_1004g [2018/02/20 18:51] – ↷ Links adapted because of a move operation bobafetthotmail | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== Asmax AR 1004g ====== | ||
| + | Hardware of Asmax AR 1004g is identical to such products as ASUS AM604g and D-Link DSL-2640B. | ||
| + | |||
| + | ==== Hardware info ==== | ||
| + | ^ ADSL2+ Chip with CPU MIPS32 ^ FLASH 4MB ^ SDRAM 16MB ^ Switch | ||
| + | | Broadcom BCM6348SKFBG | SST SST39VF3201 | AOTOM A641604L-6TE x2 | Broadcom BCM5325EKQMG | Broadcom BCM4318KFBG | Broadcom BCM6301KSG | | ||
| + | |||
| + | ==== CFE startup output ==== | ||
| + | |||
| + | |< | ||
| + | Build Date: ËÄ 3ÔÂ 26 11:25:24 CST 2009 (root@hpp) | ||
| + | Copyright (C) 2000-2006 Broadcom Corporation. | ||
| + | |||
| + | Boot Address 0xbfc00000 | ||
| + | |||
| + | Initializing Arena. | ||
| + | Initializing Devices. | ||
| + | Parallel flash device: name SST39VF3201, | ||
| + | Flash Layout: Boot[63, | ||
| + | AuxFS[61, | ||
| + | Flash RootFS Partition Length: 3932160 | ||
| + | CPU type 0x29107: 256MHz, Bus: 128MHz, Ref: 32MHz | ||
| + | Total memory: 16777216 bytes (16MB) | ||
| + | |||
| + | Total memory used by CFE: 0x80401000 - 0x80525230 (1196592) | ||
| + | Initialized Data: 0x8041CB00 - 0x8041EA50 (8016) | ||
| + | BSS Area: 0x8041EA50 - 0x80423230 (18400) | ||
| + | Local Heap: 0x80423230 - 0x80523230 (1048576) | ||
| + | Stack Area: 0x80523230 - 0x80525230 (8192) | ||
| + | Text (code) segment: | ||
| + | Boot area (physical): | ||
| + | Relocation Factor: | ||
| + | |||
| + | Board IP address | ||
| + | Host IP address | ||
| + | Gateway IP address | ||
| + | Run from flash/host (f/h) : f | ||
| + | Default host run file name : vmlinux | ||
| + | Default host flash file name : bcm963xx_fs_kernel | ||
| + | Boot delay (0-9 seconds) | ||
| + | Board Id (0-8) : 96348GW-10 | ||
| + | Number of MAC Addresses (1-32) | ||
| + | Base MAC Address | ||
| + | PSI Size (1-64) KBytes | ||
| + | Flash Block Size (1-128) in KBytes: 0 | ||
| + | Auxillary File System Size Percent: 0 | ||
| + | |||
| + | udp_send finished | ||
| + | No answer .auto boot ... | ||
| + | *** Press any key to stop auto run (1 seconds) ***</ | ||
| + | |||
| + | ==== Serial port ==== | ||
| + | {{media: | ||
| + | |||
| + | VCC = 3.3 V, speed 115200 | ||
| + | |||
| + | More infos: [[docs: | ||
| + | |||
| + | ==== JTAG ==== | ||
| + | {{media: | ||
| + | |||
| + | nTRST 1 2 GND | ||
| + | TDI 3 4 GND | ||
| + | TDO 5 6 GND | ||
| + | TMS 7 8 GND | ||
| + | TCK 9 10 GND | ||
| + | nSRST 11 12 GND | ||
| + | |||
| + | More infos: [[docs: | ||
| + | |||
| + | ==== Software ==== | ||
| + | * [[https:// | ||
| + | * [[ftp:// | ||
| + | * [[ftp:// | ||
| + | |||
| + | ==== Install OpenWrt / Restore original firmware ==== | ||
| + | - Press and hold RESET button | ||
| + | - Turn on router, after 10-15 sec release RESET | ||
| + | - Web browser -> 192.168.1.1 and upload firmware | ||
| + | |||
| + | ===== Tags ===== | ||
| + | [[meta: | ||
| + | {{tag> | ||