Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| toh:arcadyan:astoria:aw1000 [2024/05/28 21:33] – add usb boot frauhottelmann | toh:arcadyan:astoria:aw1000 [2024/09/07 18:32] – [Arcadyan / Astoria AW1000] frollic | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Arcadyan / Astoria AW1000 ====== | ====== Arcadyan / Astoria AW1000 ====== | ||
| - | |||
| - | {{page> | ||
| {{: | {{: | ||
| Line 38: | Line 36: | ||
| 1. Set your PC’s Ip address to 192.168.1.10 and connect it to your router on port 1 of the yellow ports. | 1. Set your PC’s Ip address to 192.168.1.10 and connect it to your router on port 1 of the yellow ports. | ||
| + | |||
| 2. Download the initramfs image, rename it to initramfs.bin, | 2. Download the initramfs image, rename it to initramfs.bin, | ||
| - | 3. Connect to your router via Serial | + | |
| + | 3. Connect to your router via [[: | ||
| 4. In your serial software, press Esc-key to interrupt U-Boot while turning on the router and run these commands: | 4. In your serial software, press Esc-key to interrupt U-Boot while turning on the router and run these commands: | ||
| setenv serverip 192.168.1.10 | setenv serverip 192.168.1.10 | ||
| Line 163: | Line 164: | ||
| /* Thanks, your wiki administration - Oct. 2015 */ | /* Thanks, your wiki administration - Oct. 2015 */ | ||
| - | **Insert photo of front of the casing** | + | {{: |
| - | **Insert photo of back of the casing** | + | {{: |
| - | **Insert photo of backside label** | + | {{: |
| **Insert photo of PCB** | **Insert photo of PCB** | ||
| Line 178: | Line 179: | ||
| -> [[docs: | -> [[docs: | ||
| - | Serial port on board is marked with J1003 near the LEDs plastic extension, with The square hole being VCC (do not connect this!), farthest from the square is ground, then rx, then tx. (GND-RX-TX-VCC). | + | Serial port on board is marked with J1003 near the LEDs plastic extension, with the square hole being Vcc (do not connect this!), farthest from the square is ground, then rx, then tx. (GND-RX-TX-VCC). |
| - | **Insert photo of PCB with markings for serial port** | + | |
| ^ Serial connection parameters\\ for Arcadyan / Astoria AW1000 | 115200, 8N1, 3.3V | | ^ Serial connection parameters\\ for Arcadyan / Astoria AW1000 | 115200, 8N1, 3.3V | | ||
| + | {{: | ||
| ===== Upgrade modem firmware ===== | ===== Upgrade modem firmware ===== | ||