ALLNET ALL0258N

This device is NOT RECOMMENDED for future use with OpenWrt due to low flash/ram.
DO NOT BUY DEVICES WITH 4MB FLASH / 32MB RAM if you intend to flash an up-to-date and secure OpenWrt version onto it! See 4/32 warning for details.

1) This device does not have sufficient resources (flash and/or RAM) to provide secure and reliable operation.
This means that even setting a password or changing simple network settings might not be possible any more, rendering the device effectively useless. See OpenWrt on 4/32 devices what you can do now.

2) OpenWrt support for this device has ended in 2022.
19.07.10 was the last official build for 4/32 devices.

The ALL0258N is an access-point/client/bridge system with outdoor IP54 enclosure.
Support for the board used in the device was added to OpenWrt trunk.

Install OpenWrt (generic explanation)

FIXME Please add the installation procedure here.

Since this part is identical for all devices, see Basic configuration.

Architecture MIPS
Vendor Qualcomm Atheros
SoC Atheros AR7240 rev 2
CPU speed 350 MHz
Flash size 8 MiB
RAM size 32 MiB
WLAN Atheros AR9285 (802.11b/g/n, MIMO, 150 Mb/s)
LAN RJ45 10/100 Mb/s Fast Ethernet
Power supply proprietary 24V=/0.6A PoE adapter

¹ This device is supposed to be electrically identical to the Engenius devices ENH200, ENH200EXT and ENH202 (source http://www.wikidevi.com/wiki/EnGenius_ENH200). The proprietary Engenius firmware supports VLAN tagging on ethernet network interface (remark: so does OpenWrt, just set the physical interface name of the lan interface to eth0.77 instead of eth0 to communicate on VLAN 77).

This website uses cookies. By using the website, you agree with storing cookies on your computer. Also you acknowledge that you have read and understand our Privacy Policy. If you do not agree leave the website.More information about cookies
  • Last modified: 2024/02/12 08:58
  • by 127.0.0.1