Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| toh:airlink101:ar670w [2015/10/23 18:16] – ↷ Links adapted because of a move operation tmomas | toh:airlink101:ar670w [2018/07/25 22:06] – [Installation] leitec | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== Airlink101 AR670W ====== | ||
| + | {{media: | ||
| + | ===== Supported Versions ===== | ||
| + | ---- datatable ---- | ||
| + | cols : Brand, Model, Versions, Supported Current Rel, OEM device homepage URL_url, OWrt Forum Topic URL_url, Device Techdata_pageid | ||
| + | headers : Brand, Model, Version, Current Release, OEM Info, Forum Topic, Technical Data | ||
| + | align : c, | ||
| + | filter | ||
| + | ---- | ||
| + | |||
| + | |||
| + | ===== Hardware Highlights ===== | ||
| + | ---- datatable ---- | ||
| + | cols : Model, Versions, CPU, CPU MHz, Flash MB_mbflashs, | ||
| + | header | ||
| + | align : c, | ||
| + | filter | ||
| + | ---- | ||
| + | |||
| + | |||
| + | ===== Installation ===== | ||
| + | ---- datatable ---- | ||
| + | cols : Model, Versions, Supported Current Rel, Firmware OpenWrt Install URL_url, Firmware OpenWrt Upgrade URL_url, Firmware OEM Stock URL_url | ||
| + | headers : Model, Version, Current Release, Firmware OpenWrt Install, Firmware OpenWrt Upgrade, Firmware OEM Stock | ||
| + | align : l,c,c | ||
| + | filter | ||
| + | ---- | ||
| + | |||
| + | -> [[docs: | ||
| + | |||
| + | |||
| + | The stock firmware has a recovery mode triggered by holding down the reset button on power-up or hitting escape at the serial console. The recovery interface is accessible via HTTP at 192.168.1.10. The OpenWrt '' | ||
| + | |||
| + | When connected to the serial console, it is possible to drop into a u-boot prompt by hitting ' | ||
| + | |||
| + | ===== Hardware ===== | ||
| + | |||
| + | ==== Networking ==== | ||
| + | The SoC's builtin Ethernet is connected to a IP175C 5-port 100mbit switch. VLAN setup is supported in OpenWRT. | ||
| + | |||
| + | ==== Serial Port ==== | ||
| + | The serial port is located at JP2 on the board. The baud rate is 57600. | ||
| + | |||
| + | < | ||
| + | Pin 1 Rx | ||
| + | Pin 2 ABSENT | ||
| + | Pin 3 3.3V | ||
| + | Pin 4 GND | ||
| + | Pin 5 Tx | ||
| + | </ | ||
| + | |||
| + | ===== Tags ===== | ||
| + | [[meta: | ||
| + | {{tag> | ||