Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
Next revisionBoth sides next revision
toh:airlink101:ar670w [2014/12/06 13:24] – created leitectoh:airlink101:ar670w [2018/07/25 22:06] – [Installation] leitec
Line 1: Line 1:
 +====== Airlink101 AR670W ======
 +{{media:airlink101:ar670w_case.jpg?direct&300|}}
  
 +===== Supported Versions =====
 +---- datatable ----
 +cols    : Brand, Model, Versions, Supported Current Rel, OEM device homepage URL_url, OWrt Forum Topic URL_url, Device Techdata_pageid
 +headers : Brand, Model, Version, Current Release, OEM Info, Forum Topic, Technical Data
 +align   : c,c,c,c,c,c,c
 +filter  : Model=AR670W
 +----
 +
 +
 +===== Hardware Highlights =====
 +---- datatable ----
 +cols    : Model, Versions, CPU, CPU MHz, Flash MB_mbflashs, RAM MB_mbram, WLAN Hardware, WLAN 2.4GHz, WLAN 5.0GHz, Ethernet 100M ports_, Ethernet Gbit ports_, Modem, USB ports_
 +header  : Model, Version,SoC,CPU MHz,Flash MB,RAM MB,WLAN Hardware,WLAN2.4,WLAN5.0,100M ports,Gbit ports,Modem,USB
 +align   : c,c,c,c,c,c,c,c,c,c,c,c,c
 +filter  : Model=AR670W
 +----
 +
 +
 +===== Installation =====
 +---- datatable ----
 +cols    : Model, Versions, Supported Current Rel, Firmware OpenWrt Install URL_url, Firmware OpenWrt Upgrade URL_url, Firmware OEM Stock URL_url
 +headers : Model, Version, Current Release, Firmware OpenWrt Install, Firmware OpenWrt Upgrade, Firmware OEM Stock
 +align   : l,c,c
 +filter  : Model=AR670W
 +----
 +
 +-> [[docs:guide-user:installation:generic.flashing|Install OpenWrt (generic explanation)]]
 +
 +
 +The stock firmware has a recovery mode triggered by holding down the reset button on power-up or hitting escape at the serial console. The recovery interface is accessible via HTTP at 192.168.1.10. The OpenWrt ''factory'' image is compatible.
 +
 +When connected to the serial console, it is possible to drop into a u-boot prompt by hitting 'q' in recovery mode. Note that there is no saved u-boot environment on flash, so you will have to set e.g. ''serverip'' every time you need to use TFTP.
 +
 +===== Hardware =====
 +
 +==== Networking ====
 +The SoC's builtin Ethernet is connected to a IP175C 5-port 100mbit switch. VLAN setup is supported in OpenWRT.
 +
 +==== Serial Port ====
 +The serial port is located at JP2 on the board. The baud rate is 57600.
 +
 +<code>
 +Pin 1 Rx
 +Pin 2 ABSENT
 +Pin 3 3.3V
 +Pin 4 GND
 +Pin 5 Tx
 +</code>
 +
 +===== Tags =====
 +[[meta:tags|How to add tags]]
 +{{tag>RT2880 4flash 32ram}}
  • Last modified: 2024/02/12 08:58
  • by 127.0.0.1