Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| toh:adb:p.dg_av4202n [2018/02/20 18:51] – ↷ Links adapted because of a move operation bobafetthotmail | toh:adb:p.dg_av4202n [2023/06/19 16:57] – datatables danitool | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== ADB P.DG AV4202N ====== | ====== ADB P.DG AV4202N ====== | ||
| - | Not supported yet.\\ | + | {{section> |
| - | Original source code from ADB based on OpenWRT | + | |
| + | {{section> | ||
| + | |||
| + | Original source code from ADB based on OpenWrt | ||
| Other Names: | Other Names: | ||
| Line 9: | Line 12: | ||
| There is a version that supports fibreglass connection (the port being between the Ethernet ports and the phone port) maybe some unused pins are used in that version of the router, the original source code was supposed to also be for the router including this feature . | There is a version that supports fibreglass connection (the port being between the Ethernet ports and the phone port) maybe some unused pins are used in that version of the router, the original source code was supposed to also be for the router including this feature . | ||
| - | ===== Hardware ===== | ||
| - | ==== Info ==== | ||
| - | | **[[wp> | ||
| - | | **Vendor: | ||
| - | | **[[docs: | ||
| - | | **Board ID:** | 96368_Swiss_S1 | | ||
| - | | **[[docs: | ||
| - | | **[[docs: | ||
| - | | **Flash-Chip: | ||
| - | | **Flash size** | ||
| - | | **RAM** | ||
| - | | **Wireless** | ||
| - | | **Ethernet: | ||
| - | | **USB** | ||
| - | | **Antenna** | ||
| - | | **[[docs: | ||
| - | | **[[docs: | ||
| - | ==== Photos | + | ===== Supported Versions ===== |
| - | The top side of the PCB with removed shield and heatsink:\\ | + | ---- datatable ---- |
| - | {{:media:pirelli:av4202n_top.jpg? | + | cols |
| + | headers | ||
| + | align : c, | ||
| + | filter | ||
| + | ---- | ||
| - | The bottom side:\\ | ||
| - | {{: | ||
| - | ==== Serial | + | ===== Hardware Highlights ===== |
| - | -> [[docs:hardware: | + | ---- datatable ---- |
| - | The serial | + | cols |
| + | header | ||
| + | align : c, | ||
| + | filter | ||
| + | ---- | ||
| - | | 1 | RX | GND | 2 | | + | ===== Installation ===== |
| - | | 3 | + | ---- datatable ---- |
| - | | 5 | TX | GND | 6 | | + | cols : Brand, Model, Versions, Supported Current Rel, Firmware OpenWrt Install URL_url, Firmware OEM Stock URL_url |
| + | headers : Brand, Model, Version, Current Release, Firmware OpenWrt Install & Upgrade, Firmware OEM Stock | ||
| + | align | ||
| + | filter | ||
| + | ---- | ||
| - | ===== Installation ===== | ||
| ==== Install by Webinterface ==== | ==== Install by Webinterface ==== | ||
| You must set your TCP/IP v4 protocol to: | You must set your TCP/IP v4 protocol to: | ||
| Line 53: | Line 48: | ||
| - Press reset button near the antenna. | - Press reset button near the antenna. | ||
| - Keep it pressed while powering up during ~20+ seconds. | - Keep it pressed while powering up during ~20+ seconds. | ||
| - | - Acces to http:// | + | - Browse |
| - Wait until router reboots. | - Wait until router reboots. | ||
| ====Install by Serial Console==== | ====Install by Serial Console==== | ||
| - | | + | - Install |
| - | < | + | |
| sudo su - | sudo su - | ||
| apt-get install tftpd-hpa screen | apt-get install tftpd-hpa screen | ||
| Line 69: | Line 63: | ||
| # attach board eth0.1 to lan (second port, on the yellow block) | # attach board eth0.1 to lan (second port, on the yellow block) | ||
| </ | </ | ||
| - | + | - plug usb to ttl cable < | |
| - | * plug usb to ttl cable | + | |
| - | < | + | |
| cd | cd | ||
| screen -L / | screen -L / | ||
| - | </ | + | </ |
| - | power on the router and press enter within 1 sec to get into CFE console | + | |
| - | + | <nowiki> | |
| - | * Configure Router and Install Firmware | + | |
| - | <code> | + | |
| CFE> help | CFE> help | ||
| Available commands: | Available commands: | ||
| Line 223: | Line 213: | ||
| Auto run second count down: 0 | Auto run second count down: 0 | ||
| Booting BRCM native image (0xb8020000) ... | Booting BRCM native image (0xb8020000) ... | ||
| - | </code> | + | </nowiki> |
| + | </ | ||
| ==== Post Installation Tasks ==== | ==== Post Installation Tasks ==== | ||
| Line 254: | Line 245: | ||
| </ | </ | ||
| + | |||
| + | ===== Hardware ===== | ||
| + | ==== Info ==== | ||
| + | ^ [[wp> | ||
| + | ^ Vendor | ||
| + | ^ [[docs: | ||
| + | ^ Board ID | 96368_Swiss_S1 | | ||
| + | ^ [[docs: | ||
| + | ^ [[docs: | ||
| + | ^ Flash-Chip | ||
| + | ^ Flash size | 16 MiB | | ||
| + | ^ RAM | 64 MiB | | ||
| + | ^ Wireless | ||
| + | ^ Ethernet | ||
| + | ^ USB | 2x USB2.0 | ||
| + | ^ Antenna | ||
| + | ^ [[docs: | ||
| + | ^ [[docs: | ||
| + | |||
| + | ==== Photos ==== | ||
| + | The top side of the PCB with removed shield and heatsink:\\ | ||
| + | {{: | ||
| + | |||
| + | The bottom side:\\ | ||
| + | {{: | ||
| + | |||
| + | ==== Serial ==== | ||
| + | -> [[docs: | ||
| + | The serial header is the J5 (below the heatsink). The pinout is the following: | ||
| + | |||
| + | | 1 | RX | GND | 2 | | ||
| + | | 3 | 3V3 | GND | 4 | | ||
| + | | 5 | TX | GND | 6 | | ||
| ==== OpenWrt Boot Log ==== | ==== OpenWrt Boot Log ==== | ||
| - | <code> | + | <WRAP bootlog> |
| + | <nowiki> | ||
| *** Press any key to stop auto run (1 seconds) *** | *** Press any key to stop auto run (1 seconds) *** | ||
| Auto run second count down: 0 | Auto run second count down: 0 | ||
| Line 423: | Line 448: | ||
| [ | [ | ||
| [ | [ | ||
| - | </code> | + | </nowiki> |
| + | </ | ||
| ==== Some interesting Details ==== | ==== Some interesting Details ==== | ||
| - | <code> | + | <WRAP bootlog> |
| + | <nowiki> | ||
| root@OpenWrt:/# | root@OpenWrt:/# | ||
| dev: size | dev: size | ||
| Line 631: | Line 658: | ||
| [ 189.608000] IPv6: ADDRCONF(NETDEV_CHANGE): | [ 189.608000] IPv6: ADDRCONF(NETDEV_CHANGE): | ||
| [ 190.644000] br-lan: port 1(eth0.1) entered forwarding state | [ 190.644000] br-lan: port 1(eth0.1) entered forwarding state | ||
| - | </code> | + | </nowiki> |
| + | </ | ||
| ==== Interesting unpopulated parts ==== | ==== Interesting unpopulated parts ==== | ||
| Line 647: | Line 675: | ||
| ===== Tags ===== | ===== Tags ===== | ||
| [[meta: | [[meta: | ||
| - | {{tag> | + | {{tag> |