Fulltext results:

OpenSSL Benchmarks @docs:guide-user:perf_and_log

21 Hits, Last modified: 19 hours ago

| 28.2 | 23.1 | | r36088 | Atheros AR7161 rev 2 | NETGEAR WNDR3700/WNDR3800/WNDRMAC | MIPS 24Kc V7.4 | 452.19 | 1.0.... | 15.1 | 13.7 | | r48532 | Atheros AR7161 rev 2 | NETGEAR WNDR3700/WNDR3800/WNDRMAC | MIPS 24Kc V7.4 | 452.19 | 1.0.... .4 | 39.4 | | r11208 | Qualcomm Atheros IPQ8065 | Netgear Nighthawk X4S R7800 | ARMv7 Processor rev 0 (v7l)... 00 | 1439000 | 1186000 | 1.8 | 79 | 7.7 | 6.8 | | Netgear WNR854T | 332.59 | Attitude r25661 | Marvell Orio

NETGEAR WNDR4300 v1 @toh:netgear

46 Hits, Last modified: 2 days ago

of the router says //WNDR4300//. Similar to [[toh:netgear:WNDR3700]]**v4** but 3T3R. OpenWrt forum [[https://forum.o... ing|Install OpenWrt (generic explanation)]] The Netgear WNDR3700(v4) [[toh:netgear:wndr3700#installation|installation instructions]] are appl... tftp'd directly to the router (the chapter [[toh:netgear:wndr3700#recovery_flash_in_failsafe_mode|Recovery flash in failsafe mode]] of the Netgear WNDR3700 page is applicable for WNDR4300 too). - set a

OpenWrt 19.07.4 - Service Release - 10 September 2020 @releases:19.07

4 Hits, Last modified: 7 days ago

es === * **Fix wifi range and throughput** for WNDR3700, WNDR3800 ([[flyspray>3088|FS#3088]]) * **Fix b... OM WRC-1900GST and WRC-2533GST, GL.inet GL-AR150, Netgear DGND3700 v1, Netgear DGND3800B, Netgear WNR612 v2, TP-Link TL-WR802N v1/v2, TP-Link TL-MR3020, TP-Link TL-WR841ND v8, TP-Link C

OpenWrt 19.07.4 - 服务版本 - 2020 年 9 月 10 日 @zh:releases:19.07

4 Hits, Last modified: 10 days ago

提供支持: TP-Link TL-WR710N v2.1 === 现存设备 === * 为 WNDR3700, WNDR3800 **修正 wifi 范围和吞吐量** ([[flyspray>3088|FS#... OM WRC-1900GST and WRC-2533GST, GL.inet GL-AR150, Netgear DGND3700 v1, Netgear DGND3800B, Netgear WNR612 v2, TP-Link TL-WR802N v1/v2, TP-Link TL-MR3020, TP-Link TL-WR841ND v8, TP-Link C

Netgear R7800 (Nighthawk X4S AC2600) @toh:netgear

134 Hits, Last modified: 11 days ago

ery mode in the bootloader, similar as some other Netgear routers e.g. WNDR3700. **Prerequisites for TFTP flashing** * A TFTP... * A new firmware to flash in. Either an original Netgear firmware or an Openwrt "factory.img" firmware. "S... is no requirement to wait for 10 flashes although Netgear apparently says that in official advice. You can ... arm_cortex-a15_neon-vfpv4 | ^ Vendor | Netgear | ^ Bootloader | U-Boot | ^ System-On-Chip

fwfiles_snapshots @meta

202 Hits, Last modified: 13 days ago

300-squashfs-sysupgrade.bin openwrt-ath79-generic-netgear_wndr3700-initramfs-kernel.bin openwrt-ath79-generic-netgear_wndr3700-squashfs-factory.img openwrt-ath79-generic-netgear_wndr3700-squashfs-sysupgrade.bin openwrt-ath79-generic-netgear_wndr3700-v2-initramfs-kernel.bin openwrt-ath79-generic-netgea

Documentación @es:docs

5 Hits, Last modified: 3 weeks ago

na ^ Descripción ^ | [[docs:guide-developer:build.wndr3700|Netgear WNDR3700]] | Construyendo el firmware de Netgear WNDR3700 | | [[doc:howtobuild:build.dockstar|Seagate Dockstar]] | Construyendo el firmware de Seagate Docks

fwfiles_19.07.4 @meta

96 Hits, Last modified: 3 weeks ago

shfs-sysupgrade.bin openwrt-19.07.4-ath79-generic-netgear_wndr3700-initramfs-kernel.bin openwrt-19.07.4-ath79-generic-netgear_wndr3700-squashfs-factory.img openwrt-19.07.4-ath79-generic-netgear_wndr3700-squashfs-sysupgrade.bin openwrt-19.07.4-ath79-gen... -v3-squashfs.chk openwrt-19.07.4-brcm47xx-mips74k-netgear-wndr3700-v3-squashfs.chk openwrt-19.07.4-brcm47xx-mips74k-

OpenWrt v19.07.4 Changelog @releases:19.07

4 Hits, Last modified: 3 weeks ago

9|f7f15f8]]'' **<nowiki>ath79:</nowiki>** <nowiki>wndr3700 series: fix wifi range & throughput</nowiki> //<c... '' **<nowiki>brcm47xx:</nowiki>** <nowiki>disable Netgear WNR2000 v2 by default</nowiki> //<color #ccc>(</c... ased WiFi range switching from ar71xx to ath79 on WNDR3700</nowiki>\\ **Link:** [[https://bugs.openwrt.org/i... 9|f7f15f8]]'' **<nowiki>ath79:</nowiki>** <nowiki>wndr3700 series: fix wifi range & throughput</nowiki> //<c

Installing OpenWrt @docs:guide-user:installation

7 Hits, Last modified: 3 weeks ago

ch, just so long as it's not the WAN port) of the WNDR3700. - connect your serial cable to the header on the WNDR3700 and set your local terminal program (eg. minicom)... t it's recognized by the u-Boot firmware. Use the wndr3700.c program that was posted by *aorlinsk* on the forums here http://aorlinsk2.free.fr/openwrt/wndr3700/ and run it from the TFTP server's data directory