Search

You can find the results of your search below.

NETGEAR WNDR4300 v1 @toh:netgear
46 Hits, Last modified:
of the router says //WNDR4300//. Similar to [[toh:netgear:WNDR3700]]**v4** but 3T3R. OpenWrt forum [[https://forum.o... ing|Install OpenWrt (generic explanation)]] The Netgear WNDR3700(v4) [[toh:netgear:wndr3700#installation|installation instructions]] are appl... tftp'd directly to the router (the chapter [[toh:netgear:wndr3700#recovery_flash_in_failsafe_mode|Recovery flash in failsafe mode]] of the Netgear WNDR3700 page is applicable for WNDR4300 too). - set a
Unlocking the Netgear Telnet Console @toh:netgear
75 Hits, Last modified:
you should be dropped on a '#' prompt. * [[toh:netgear:WNDR3700]] V1.0.7.98: known to work - does not ask for use... ion you will be root at BusyBox v1.4.2. * [[toh:netgear:WNDR3800]] v1.0.0.16 Tested with the python script of telnetenable. * [[toh:netgear:WNDR4000]] v1.0.0.88 works. Does NOT ask for user... you should be dropped on a '#' prompt. * [[toh/netgear/WNDR4300]] V1.0.1.30/34/42 works with the python
Netgear D7800 @toh:netgear
20 Hits, Last modified:
ery mode in the bootloader, similar as some other Netgear routers e.g. WNDR3700. The following steps are from [[toh/netgear/r7800|Netgear R7800]] page which works with D7800. **Prerequisites for TFTP flashing** * A TFTP client... * A new firmware to flash in. Either an original Netgear firmware or an Openwrt "factory.img" firmware. "S
D-Link DIR-825 @toh:d-link
6 Hits, Last modified:
ed the bootloader/calibration data partition from Netgear WNDR3700. It's done through a full reflash, check the foru... or the binary. It turn the D-Link DIR-825 into an Netgear WNDR3700. The Netgear stock firmware does not recognize the 128 MB RAM, it only shows/uses 64 MB RAM, but it start... | | | your local LAN | Switch Netgear ProSafe 5 | 192.168.1.1 | | |
  • Last modified: 2020/12/09 22:33
  • by hauke