Search

You can find the results of your search below.

Linksys EA8300
132 Hits, Last modified:
with OpenWrt firmwares, and you won't be able to revert back to Linksys OEM firmware using above method. ==== JTAG ... = (0/0/48000000/0) 256 MiB MMC: qca_mmc: 0 PCI0 Link Intialized In: serial Out: serial Err: ser... 0 addr:0:3:7f:ba:db:ad PHY ID1: 0x4d PHY ID2: 0xd0b1 ipq40xx_ess_sw_init done eth0 Updating boot_coun... = (0/0/48000000/0) 256 MiB MMC: qca_mmc: 0 PCI0 Link Intialized In: serial Out: serial Err: ser
Linksys WRT1900AC
105 Hits, Last modified:
====== Linksys WRT1900AC ====== /* This template is intended to be used via https://openwrt.org/meta/cr... age */ The WRT1900AC was the first of the [[toh:linksys:wrt_ac_series]] to be released. It featured 4 ... .11ac wave 1 (80MHz) capable device.\\ The second revision of the hardware removed the internal cooling... bles are loaded into the device due to moves from Linksys in response to FCC changes. It also changed to
Linksys WRT1200AC
89 Hits, Last modified:
inistration - Oct. 2015 */ //Front://\\ {{:media:linksys:linksys_wrt1200_ac_front.jpg?direct&400|**Front of the casing**}} //Back://\\ {{:media:linksys:linksys_wrt1200ac_back.jpg?direct&400|**Back of the casing**}} //Backside label://\\ {{:media:linksys:linksys_wrt1200ac_label.jpg?direct&400|**Backside label**}} ==== Opening the cas... lide into the rear feet //Main PCB://\\ {{:media:linksys:linksys_wrt1200ac_pcb.jpg?direct&400|**Photo of assembled PCB top view}} ===
Linksys E1200 v2
84 Hits, Last modified:
with only a Linksys logo. Linksys E1200 v2 with Linksys logo: was able to install 15.05.1 by upgrading firmware directly from linksys firmware, but wireless is not s... e=4096 N_HDLC line discipline registered. Serial: 8250/16550 driver $Revision: 1.1.1.1 $ 4 ports, IRQ sharing disabled ser... tplug2 --coldplug & ] /dev/nvram: No such file or directory /dev/nvram: No such file or directory /dev/nvram: No such file or directory /dev/nvram: No such
Linksys EA7500 V1
81 Hits, Last modified:
r Using interface ath0 with hwaddr c0:56:27:39:aa:b1 and ssid "Linksys" ath0: interface state UNINITIALIZED->ENABLED ... face ath1 with hwaddr c0:56:27:39:aa:b2 and ssid "Linksys 5" ath1: interface state UNINITIALIZED->ENABLE... eed/mode) = (0/0/48000000/0) 128 MiB MMC: PCI0 Link Intialized PCI1 Link Intialized In: serial Out: serial Err: serial cdp: get part failed for 0:HL
  • Last modified: 2020/12/09 22:33
  • by hauke