Search
You can find the results of your search below.
Fulltext results:
- Ubiquiti UniFi AP AC @toh:ubiquiti
- ====== Ubiquiti UniFi AP AC ====== Ubiquiti has released a new series of UniFi APs supporting AC in Q4/2015 and two similar devices under the "Mesh" label in 2017. * UniFi AP AC Lite * UniFi AC Mesh * UniFi AP AC Pro * UniFi AC Mesh Pro * UniFi AP AC LR (Long Ra... ) -- NOT SUPPORTED :!: For OpenWrt/LEDE on the Unifi AP AC Pro/Mesh Pro, LAN and WAN port assignment is "unexpected." LAN
- Ubiquiti NanoBeam AC @toh:ubiquiti
- The [[https://www.ui.com/airmax/nanobeam-ac-gen2|Ubiquiti NanoBeam™ AC]] are lightweight proprietary (based on 802.11ac) outdoor access points... y code should be used [ 12.865797] ath: doing EEPROM country->regdmn map search [ 12.865814] ath: country maps to regdmn code: 0x3a [ 12.865820] ath: Country alpha2 being... failed to initialize device [ 12.962195] ath9k: probe of 18100000.wmac failed with error -5 [ 13.05
- Ubiquiti UniFi AC HD @toh:ubiquiti
- ====== Ubiquiti UniFi AC HD ====== The Ubiquiti UniFi AC HD (also called UniFi HD, UAP-HD, UAP-AC-HD) is a 4×4 802.11ac Wave 2 access point with a dual-core ARM processor and 512 MB of RAM. {{:media:ubiquiti:uap-ac-hd_front.jpg?200|Ubiquiti UniFi AC HD}} ===== Supported Versions ===== ---- dat... mtd8** \\ ''APPSBL'' \\ 768 KiB | **mtd9** \\ ''APPSBLENV'' \\ 64 KiB | **mtd10** \\ ''EEPROM'' \\ 64 KiB | **mtd11** \\ ''bootselect'' \\ 6... l reset the configuration (U-Boot environment and Ubiquiti firmware config partition "cfg") and overwrite the APPSBL, SBL1, SBL2, SBL3, TZ, RPM, kernel0 and boots
- Ubiquiti Nanostation AC loco @toh:ubiquiti
- v8.7.0 / XC v8.7.0** See instructions in [[:toh:ubiquiti:common|Common Procedures for Ubiquiti Products]] **WA v8.5.7** See instructions in [[:toh:ubiquiti:common|Common Procedures for Ubiquiti Products]] **WA v8.5.0** The firmware for this Ubiq... ot always an option. In those cases, an alternate procedure is documented [[toh/ubiquiti/common|here]]. Following reflash, the radios ar... y code should be used [ 12.039141] ath: doing EEPROM country->regdmn map search [ 12.039158] ath: country maps to regdmn
- Ubiquiti LiteAP AC @toh:ubiquiti
- ====== Ubiquiti LiteAP AC ====== The [[https://www.ui.com/airmax/liteap-ac/|Ubiquiti LiteAP AC]] is a family of lightweight 802.11ac out... receiver and a 2.4 GHz management radio {{:media:ubiquiti:ubt_lap-120_front.jpg?150x150|Device front view (click to show full image)}} {{:media:ubiquiti:ubt_lap-120_conn.jpg?150x150|Device connector view (click
- Ubiquiti LiteAP AC (LAP-120 or LBE-5AC-16-120) @toh:ubiquiti
- ====== Ubiquiti LiteAP AC (LAP-120 or LBE-5AC-16-120) ====== {{page>meta:infobox:construction&noheader&nofooter&noeditbtn}} The [[https://www.ui.com/airmax/liteap-ac/|Ubiquiti LiteAP AC]] (LAP-120) previously known as LiteBea... Ethernet port based on the AR9342 SoC. {{:media:ubiquiti:ubt_lap-120_front.jpg?250x200|Device front view (click to show full image)}} {{:media:ubiquiti:ubt_lap-120_conn.jpg?250x200|Device connector view (click
- Ubiquiti Powerbeam 5AC @toh:ubiquiti
- 5AC-500-ISO ---- * PowerBeam 5AC Gen2 -> [[toh:ubiquiti:common#openwrt_installation_on_wa_and_xc_boards|Common Procedures for Ubiquiti Products (WA-type)]] * PowerBeam 5AC 500 -> [[toh:ubiquiti:common#openwrt_installation_on_wa_and_xc_boards|Common Procedures for Ubiquiti Products (XC-type)]] * PBE-5AC-500-ISO -> [[toh:ubiquiti:common#openwrt_installation_on_w
- Ubiquiti UAP-AC-Mesh 3.7.xx.xxxx @toh:ubiquiti
- adding_images_to_openwrt_wiki */ /*****/ {{media:ubiquiti:uap-ac-mesh-front.jpg?400|Unifi Ac Mesh}} ===== OpenWrt support ===== This is essentially the same platform as UniFi AP AC LITE. Follow the instructions on [[toh:ubiquiti:unifiac|Ubiquiti OpenWrt page]] for AP AC LITE. /*** if info available: uncomment and fill in ===== Supporting activities ===== //Descr... AMPLEs and the WRAP that encloses this text. The Ubiquiti UAP-AC-Mesh has the following buttons: ^ BUTTON
- Ubiquiti Nanostation AC @toh:ubiquiti
- v8.7.0 / XC v8.7.0** See instructions in [[:toh:ubiquiti:common|Common Procedures for Ubiquiti Products]] **WA v8.5.7** See instructions in [[:toh:ubiquiti:common|Common Procedures for Ubiquiti Products]] **WA v8.4.1** The firmware for this ubiquiti device is signed. But since there are no mtd utilitie... .v8.4.1.35794.171006.1417.bin]]. The instructions probably won't work for other versions. To install un
- Ubiquiti LiteBeam 5AC Gen2 @toh:ubiquiti
- y code should be used [ 12.996825] ath: doing EEPROM country->regdmn map search [ 12.996843] ath: country maps to regdmn... y code should be used [ 13.170784] ath: doing EEPROM country->regdmn map search [ 13.170802] ath: country maps to regdmn code: 0x3a [ 13.170809] ath: Country alpha2 being... disabled state [ 26.868761] device eth0 entered promiscuous mode [ 32.906003] ath10k_pci 0000:00:00
- Ubiquiti Edgerouter 4 @toh:ubiquiti
- s currently no way to install OpenWrt through the Ubiquiti web interface. The possibilities of this happening are rather slim, given the firmware checks ... | ^ TFTP window start | approximately FILL-IN seconds after power on | ^ TFTP... -IN | </WRAP> ===== Upgrading OpenWrt ===== -> [[docs:guide-user:installation:generic.sysupgrade]] <WRAP BOX> FIXME These are generic instructions. Updat
- Ubiquiti UniFi Outdoor Plus @toh:ubiquiti
- rotocol family 16 [ 0.090000] MIPS: machine is Ubiquiti UniFiAP Outdoor+ [ 0.540000] registering PCI controlle... y code should be used [ 12.050000] ath: doing EEPROM country->regdmn map search [ 12.050000] ath: country maps to regdmn code: 0x3a [ 12.050000] ath: Country alpha2 being... 2160000 KHz), (N/A, 4000 mBm), (N/A)</nowiki> </WRAP>\\ ===== Notes ===== ===== Tags ===== [[meta:t
- Ubiquiti EdgeRouter @toh:ubiquiti
- installation via Serial and USB ==== - Get the appropriate RJ45 Console Port cable (see below for deta... | ^ TFTP window start | approximately FILL-IN seconds after power on | ^ TFTP... ootsqimg=squashfs.img rootsqwdir=w mtdparts=phys_mapped_flash:640k(boot0),640k(boot1),64k(eeprom) console=ttyS0,115200 rootwait rootflags=data=jo... 0.000000] Kernel command line: mtdparts=phys_mapped_flash:640k(boot0)ro,640k(boot1)ro,64k(eeprom)ro root=/dev/mmcblk0p2 rootfstype=squashfs,ext4
- Ubiquiti UniFi AP and AP-LR @toh:ubiquiti
- ====== Ubiquiti UniFi AP and AP-LR ====== ===== Supported Versions ===== **NOTE for UAP-v2**: As for July 2018, Ubiquiti s... 9410|this forum post]]. ==== Photos ==== {{media:ubiquiti:unifi_ap_pcb.jpg?300|}} {{:media:ubiquiti:unifi_case.png?225}}\\ ===== Specific Configuration ===== The UniFi ap has 2 leds, the orange one can be configured addi... 8.1.0/24 range, but not 192.168.1.20 (this is the Unifi AP default TFTP IP). Follow the steps to unbrick yo
- Ubiquiti EdgeRouter Pro @toh:ubiquiti
- ====== Ubiquiti EdgeRouter Pro ====== /* This template is intended to be used via https://openwrt.org/meta/create_new_devi... installation via Serial and USB ==== - Get the appropriate RJ45 Console Port cable (see below for deta... | ^ TFTP window start | approximately FILL-IN seconds after power on | ^ TFTP... standard. ^ Serial connection parameters\\ for Ubiquiti EdgeRouter Pro | 115200, 8N1 | ==== JTAG ==== -> [[docs:techref